Publicidad
Idiomas disponibles
Idiomas disponibles
Diagram
Wiring diagram. See Figure V.
CH1
Battery charger
CN1
Battery connector
CN2
Charger connector
EB1
Electronic Board
ES1
Electromagnetic switch
F1
Circuit breaker 70A
F2
Side broom fuse 15A
F3
Signal fuse 10A
M1
Main motor
M2
Side broom motor
M3
Shaker motor
R1
Shaker relay
SW1
Key switch
SW2
Hood safety switch
SW3
Skaker switch (optional)
Color code
BK
Black
BU
Blue
BN
Brown
GN
Green
GY
Grey
OG
Orange
PK
Pink
RD
Red
VT
Violet
WH
White
YE
Yellow
ELECTRICAL PROTECTIONS
Circuit breaker:
Side broom fuse:
Signal circuit fuse
ACCESSORIES / OPTIONS
In addiction to the standard components, the machine can
be equipped with the following accessories/ options,
according to the specific machine use:
1.
Gel batteries
2.
Main and side broom with harder and softer bristles
3.
Antistatic polyester or polyester BIA C dust filter
4.
Electric filter shaker
5.
Front wheel with brake pedal
6.
Different skirt types
7.
Front skirt lifting lever
For further information concerning the optional
accessories, contact an authorized retailer.
Blue 32 – 146 2301 000(1)2005-03
All manuals and user guides at all-guides.com
6, Fig. U
7, Fig. U
18, Fig. U
INSTRUCTIONS FOR USE
MACHINE USE
WARNING!
On the machine there are some decals
indicating:
- DANGER
- WARNING
- CAUTION
- CONSULTATION
Using this Manual, the operator must learn the meaning of
these symbols.
Do not cover these decals for any reason and in case of
damage, replace them immediately.
BATTERY CHECK/INSTALLATION ON A
NEW MACHINE
NOTE:
Battery charger must be connected to the
batteries for machine to function.
The machine needs a 12 V battery or two 6 V batteries
connected according to the diagram (10, Fig. U).
The machine can be equipped in one of the following
ways:
a.
A lead or gel battery installed on the machine and
ready to be used.
b.
A lead battery installed on the machine but without
electrolyte.
c.
Without a battery.
According to these conditions, follow the instructions as
described below.
a.
Lead or gel battery installed on the machine and
ready to be used.
1.
Open the hood (7, Fig. C) and check that the battery
is connected to the machine using the appropriate
connector (3, Fig. U).
2.
Lower the hood and check that it is closed correctly
(the hood must be as shown in Fig. C).
3.
Insert the ignition key (2, Fig. B) in the control panel
and turn it to the "I" position (without pulling the lever
4, Fig. C).
If the green warning light (5, Fig. B) turns on, the
battery is charged and ready to be used.
Otherwise the battery needs to be charged (refer to
the procedure in the Maintenance chapter).
b.
Lead battery installed on the machine but without
liquid electrolyte
1.
Open the machine hood (7, Fig. C).
2.
Remove the battery caps (8, Fig. U).
5
Publicidad
Capítulos
