Safety Notes; Special Features - Multiplex MULTIcont BL-17 Manual De Instrucciones

BL-17 / BL-17/II / BL-27/II / BL-37/II / BL-54 brushless controllers
! These operating instructions are an integral
part of this product. They contain important
information and safety
therefore be kept in a safe place at all times.
Be sure to pass them on to the new owner if
you ever dispose of the product.
1. S N
AFETY OTES
! Read the instructions before using the controller
! Avoid heat build-up
Provide unobstructed air circulation round the controller
! Do not connect the flight battery with reversed po-
larity
Connecting the battery leads with reversed polarity will
instantly wreck the controller
For this reason:
• red wire to the POSITIVE terminal (+)
• black wire to the NEGATIVE terminal (-)
! When soldering or working on the motor or con-
troller
Always disconnect the battery (short-circuit / injury
hazard)
! When testing and running the power system
Do not run the motor while holding it in your hand;
always secure the model firmly. Check that there is
adequate space for the propeller to rotate. Remove all
objects from the area around the propeller which could
be sucked in or blown away (clothing, paper etc.).
Never stand in the rotational plane of the propeller
(injury hazard).
2. S
PECIFICATION
MULTIcont
Order No.: # 7 2274
Max. continuous
current:
Pulse frequency:
Receiver power
supply (BEC):
Cell count with BEC
disabled:
BEC voltage:
BEC dissipated
max. 1.5 W
power:
BEC current: max. 1.5 A
Dimensions in mm
26x17x8
(approx.):
Weight incl. leads: approx. 9 g
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions MULTIcont
notes, and
BL-17 BL-17/II
# 7 2280
17 A 17 A
13 kHz
max. 3S LiPo or 9 NiXX cells
max. 3S LiPo or 12 NiXX cells
5.0 V
max. 3.0 W max. 3.0 W
max. 3.0 A
36x23x9
approx. 22 g approx 23 g
MULTIcont
Order No.:
should
Max. continuous
current:
Pulse frequency:
Receiver power
supply (BEC):
Cell count with BEC
disabled:
BEC voltage:
BEC dissipated
power:
BEC current:
Dimensions in mm
(approx.):
Weight incl. leads:
Maximum number of servos usable with MULTIcont BL
controllers in BEC mode**
MULTIcont:
NiXX cells:
LiPo cells:
Maximum number of
micro / standard
servos*:
Maximum number of
BL-27/II
high-torque
servos:
# 7 2275
* MULTIPLEX Nano-S or Tiny-S servo types.
27 A
** If the number of servos in the model exceeds the stated
maximum, it is essential to disable the BEC system and
use a separate receiver battery (
3. S
PECIAL
MULTIPLEX MULTIcont BL controllers offer an excellent
range of additional features:
• Programmable parameters
- Battery type: LiPo or NiXX
- Brake: ON or OFF
- Switchable direction of motor rotation
• BEC (Battery Eliminator Circuit)
max. 3.0 A
Receiver power supply from the flight battery
• Safe start-up system
36x24x11
Prevents accidental motor start when the flight battery
is connected
• Automatic low-voltage power cut-off with re-start (reset)
function for LiPo and NiXX cells
• Motor cut-off if serious radio interference occurs or
transmitter signal fails
BL-37/II
# 7 2276
37 A
13 kHz
max. 3S LiPo or 9 NiXX cells
max. 3S LiPo or 12 NiXX cells
5.0 V
max. 3.0 W
max. 3.0 A
38x26x10
approx. 30 g
BL-17
max. 6 max. 9
2S 3S
4 3
3 2
7.).
F
EATURES
BL-54
# 7 2277
54 A
max. 3.0 W
max. 3.0 A
51x28x9
approx. 37 g
BL-17/II
BL-27/II
BL-37/II
BL-54
max. 6 max. 9
2S 3S
5 4
4 3
Page 1/4