Milwaukee 6560 Serie Manual Del Operador página 7

Fig. 4
6560-23
Front face of plunger
Front nut
Back nut
Plunger rod
Always lock trigger or remove
battery pack before changing or
removing accessories. Only use
accessories specifically recom-
mended for this tool. Others may
be hazardous.
Installing 30oz
Assembly (Cat. No. 6560-23) (Fig. 4)
1. Lock trigger or remove battery pack.
2. Press in and hold rod release trigger.
3. Grasp plunger rod handle and pull
plunger rod back until the rod tip is just
inside of tool.
4. Release rod release trigger.
5. Insert spacer into front face of tool
body. The side with the larger diam-
eter hub fits inside the tool. Place car-
riage frame over washer. Assemble
backing washer and barrel nut to tool
as shown (Fig. 4). Tighten Barrel nut
with wrench provided.
Barrel nut
Backing
Washer
WARNING!
Carriage Frame
Nut
Plunger rod
Spacer
6. Press rod release trigger and push
plunger rod forward to access the
threads on rod.
7. Thread nuts and plunger onto the
plunger rod in order shown (Fig. 4).
Tighten back nut securely using the
wrench provided.
NOTE: Make sure the front nut and
plunger rod do not extend past the front
face of the plunger. If either part ex-
tends past the plunger, the back cap
of the material tube may rupture.
8. To remove carriage frame, reverse
procedure.
To reduce the risk of injury,
keep hands out of the plunger
area of the tool. Fingers can be
pinched between the tube holder
and the plunger.
7
Plunger
Nut
Carriage frame
WARNING!