Before You Begin - Kohler K-2517 Guía De Instalación Y Cuidado

Tools/Outils/Herramientas
2x4 Bracing
Refuerzo de 2x4
2x12
Siliconized Acrylic Caulk
Mastic à l'acrylique siliconée
Sellador acrílico siliconado

Before You Begin

WARNING: Risk of property damage. Do not modify the vanity in any way.
Doing so will compromise the structural stability of the vanity.
WARNING: Risk of property damage. Select 300 lbs (136.08 kg) load bearing lag
bolts with a length that can safely clear any obstacles in the wall. Calculate the
proper length of the lag bolts by adding the following: 1-1/2" (3.8 cm) blocking +
wall board thickness + steel bracket thickness.
NOTICE: If a lavatory/vessel will be installed: The plumbing must be roughed into
the plumbing cutout area of the vanity. Refer to the lavatory/vessel roughing-in and
the vanity roughing-in for proper placement. The water supply and drain lines must
be installed before installing the vanity.
NOTICE: Siliconized acrylic caulk must be used to secure the lavatory to the vanity.
Do not use 100% silicone sealant, which will damage the finish of the vanity.
NOTICE: To avoid the risk of product damage, the finished wall must be straight and
plumb, and the floor must be flat and perpendicular to the finished wall. If the
finished wall is not straight and plumb, and the floor is not flat and perpendicular to
the finished wall, the vanity will not be properly supported and will cause
misalignment of the lavatory and drawers.
NOTE: Plumbing fittings will be exposed and visible once the vanity installation is
complete. Plated plumbing fittings are recommended.
NOTE: The dimensions provided in this guide are for a 34-1/2" (87.6 cm) vanity
height. If an alternate height is desired, calculate the desired height of the backing
material and brackets.
NOTE: Each vanity is hand crafted. Therefore, the placement of the brackets on the
vanity may vary. To successfully install the vanity, measure and record these
dimensions when instructed to do so.
Two people should install this product.
Provide 2x12 backing material behind the finished wall to properly support the
vanity.
Make sure the finished wall is straight and plumb, and the floor is flat and
perpendicular to the finished wall.
Kohler Co.
Plus/Plus/Más:
• Lag Bolts
Tire-fond
Pernos de fijación
• Flat Washers 5/16" ID
Rondelles plates Ø 5/16" Int.
Arandelas planas de 5/16" D.E.
• Framing Nails
Clous de cadrage
Clavos para estructuras de madera
• Finishing Nails and Screws
Clous de finition
Clavos de acabado y tornillos
• Wood Shims (optional)
Cales en bois (optionnel)
Cuñas de madera (opcional)
3 1082756-2-A