Publicidad
Idiomas disponibles
Idiomas disponibles
NE 4481
KIT INCLUDES:
QTY
DESCRIPTION
1
Cargo Net
8
Staples
2
Carriage Bolts
6
Loc Nuts
4
Bolt Covers
2
Wood Loc Washers
23
3" Screws
40
2" Screws
4
Flat Washers
INSTRUCTIONS
1. Cut one 2" x 6" x 8' to 80". Cut one 2" x 6" x 8' to 40" and 43". Cut remaining
2" x 6" x 8' to 29".
2. Remove the existing 2" x 6" x 60" base board from the unit. NOTE: Save the
carriage bolts and associated hardware as they will be re-used.
3. Attach the 2" x 6" x 80" board to the base as indicated in Fig. 1 using four
3" screws at each joint. Drill through the existing holes in the post and through
the new base board. Insert previously removed carriage bolts and secure
using hardware removed earlier.
4. Attach remaining lumber to the unit as shown in Fig. 1 using three 3" screws
per joint.
5. Drill four 5/16" holes in the top board and four 3/8" holes in the bottom board
as indicated in Fig. 2. NOTE: Drill through the bottom of the 2" x 4" board to
the top. Insert the eye bolts of the Cargo Net through the holes of the top
board and secure all of them using a washer and loc nut (see Fig. 3).
NOTE: Using a hacksaw, remove excess threads of the eyebolt as close to
loc nut as possible.
6. Place bolt covers over the bolts as indicated in Fig. 3. Secure bolt covers
using 2" screws.
7. Place two rope staples as indicated in Fig. 4. Thread the Cargo Net through
the holes of the base and loop through the staples as shown (Fig. 4).
Pull tight and secure by pounding staples tight against the base.
2" x 6" x 80"
STANDARD WRANGLER™
APPLICATION
LUMBER REQUIRED
(sold separately)
QTY
DESCRIPTION
3
2" x 6" x 8'
2" x 6" x 29"
2" x 6" x 40"
2
Cargo Net
Cargo Net
6-1/2"
6-1/2" 10"
Fig. 1
Fig. 4
2" x 6" x 43"
10"
10"
10"
10"
10"
Bolt Cover
Washer and Loc
Nut
1"
1"
1"
1"
Fig. 2
Fig. 3
Publicidad
