Kenmore 81442710 Manual De Uso página 22

First try the solutions suggested here for assistance and to possibly avoid a service call.
If you experience
Washer not performing as expected (cont.)
Incorrect dispenser
operation
Powdered detergent not
dissolving completely
in load
Single-dose laundry
packet not dissolving
Error Code Appears in Display
E1 – Water inlet alarm
E2 – Draining alarm
E3 – Unbalanced alarm
E4 – Open lid alarm
E5, EA, EC, EL, or EP –
Other errors
22
TROUBLESHOOTING – WASHER (CONT.)
Possible Causes
Clogged dispensers or laundry
products dispensing too soon.
Liquid chlorine bleach or fabric
softeners not used in dispensers.
Using too much HE detergent.
Water temperature is very cold.
Adding laundry packet incorrectly.
Water level not reached after
20 minutes.
Washer is still detecting water after
draining for 8 minutes.
Washer may be tightly packed or
clothes are not evenly distributed.
Opening the lid during the Spin cycle. Close the lid.
Other
Do not overfill dispenser. Overfilling causes immediate dispensing.
Load dispensers before starting a cycle.
It is normal for small amounts of water to be remain in dispenser
at the end of the cycle.
Fabric softener thickens as it gets older. If there becomes an
increase of fabric softener in the dispenser after a cycle, check
the age of the fabric softener and replace if needed.
Use only liquid chlorine bleach in the bleach dispenser. Use only
fabric softener in the fabric softener dispenser.
Follow the manufacturer's instructions to determine the amount
of detergent to use.
Select a warmer wash temperature.
Be sure laundry packet is added to washer basket before adding
clothes. Follow the manufacturer's instructions to avoid damage
to your items.
Check that the water faucets are not closed.
Check that the water pressure in the house is over 20 kPa.
Clean the inlet hose filter screens.
Check that the drain hose is not below 27½" (700 mm) from
the floor.
Check that the drain hose is not more than 39
the floor.
Remove any clogs from the drain hose.
Remove several items, rearrange load evenly around the
washplate, and restart the Spin cycle.
Call for technical assistance – see "Assistance or Service" on the
back cover.
Solution
1 ⁄ " (100 cm) from
3