Control Panels And Features; Control Lock - Kenmore 81442710 Manual De Uso

WASHER
1 LED TIME/STATUS DISPLAY
The Remaining Time display shows the time required for
the cycle to complete. Factors such as load size and water
pressure may affect the time shown in the display. Tightly
packed loads, unbalanced loads, excessive suds, or adding
or removing items may cause the washer to adjust the cycle
time as well.
LID LOCK LIGHT
2
The Lid Lock indicator lights up when the lid is locked and
cannot be opened. If you need to open the lid, press and hold
START/PAUSE. The lid will unlock one minute after the washer
movement has stopped. This may take several minutes if the
load was spinning at high speed. Press the START/PAUSE
button again to restart the cycle.
3 START/PAUSE
After selecting a wash cycle, press START/PAUSE to start the
cycle. Press once to pause a cycle. The flashing lights indicate
the selected cycle and the current process.
CYCLE TIME (+ or -)
4
• Press "+" or "-" to adjust the duration of a cycle.
• LED display will show the time remaining for the cycle
to complete.
• If an out-of-range adjustment is made, a buzzer
will sound.
End-of-Cycle Signal
Press and hold "+" for 3 seconds to enable or disable
the end-of-cycle signal.
Press and hold "-" for 3 seconds to mute the signal.
6

CONTROL PANELS AND FEATURES

4 5
2
1
4 6
CYCLE SELECT
5
Press CYCLE SELECT to select a wash cycle. Choose from
Normal, Delicates, Heavy, Rinse, Spin, or Clean Washer.
WASH TEMP
6 6
elect a wash temperature based on the type of fabric
S
and soils being washed. For best results and following
the garment label instructions, use the warmest wash
water that is safe for your fabric.

CONTROL LOCK

Press and hold WASH TEMP for 3 seconds to lock the controls.
Press and hold for 3 seconds to unlock. You may still press
POWER to turn off the washer.
POWER
7
ress POWER to turn on or off the washer. Press once while
P
a cycle is running to stop the washer.
3
7