Página 1
Leben im Bad Living bathrooms Happy D.2 Mounting instructions One-piece water toilet Instrucciones de montaje Inodoro monopieza # 2121010001...
Index English Español Technical information Información técnica Content of packaging ....3 Contenido de la caja ..... 3 ........3 Assembly dimensions ....4 Medidas de montaje ..... 4 ........4 Mounting instructions Instrucciones de montaje Installation of the toilet ....5 Instalación del inodoro ....
# 2121010001 # 0064610000 # 0064690000 THIS CARTON CONTAINS: ESTE CARTÓN CONTIENE: 1. One-piece water toilet with tank 1. Inodoro de una pieza con cisterna lid and top actuator con tapa y accionador superior 2. Tank supplied with fill valve and 2.
" " " " 12" "-11 " " " 250-290 BEFORE YOU START: ANTES DE EMPEZAR: Please take a few minutes to read Tómese algunos minutos para leer the following installation instruc- las siguientes instrucciones de in- tions. stalación. (1.32 gpf / 0.92 gpf; 5.0 lpf / Your new one-piece water toilet is a Su Nuevo inodoro de una pieza es un 3.5 lpf)
Shut-off valve Llave de paso "-9" "-11 " 210-230 mm 250-290 mm 305 mm 12" max. / máx. " / 6,5 mm INSTALLATION OF THE TOILET If the floor flange has not been se- Place the new wax-ring around the Connect the flexible water supply Standard US installation dimen- cured to the building structure af-...
Página 6
Position toilet with a rocking motion, Alternately tighten nuts until toilet Connect the water supply line with Turn on the water at the shut-off press bowl down fully on wax-ring is firmly seated on floor. the shut-off valve. valve. and flange. Coloque el inodoro con un movi- Apriete de forma alternativa las Conecte el tubo de alimentación de...
Página 7
Open the tank cover carefully. The tank water level is factory set and should rise to the water level mark (1). Flush the tank at least three times If it is not at this level, adjust the fill valve (2) to set the water line to the and check it for leaks.
Página 8
It is recommended that the fixture be sealed around its base using sili- cone sealant. Es recomendable sellar el inodoro alrededor de su base usando sili- cona. MAL_56819/07.13.1...
- Water level is too low can seriously damage fittings in the tank. This damage can cause leakage and property damage. DURAVIT shall not be responsible or liable for any tank fitting failure or NO FLUSHING damage caused by the use of in-tank bowl cleaner.
20 psi. DURAVIT no se responsabiliza por fallos en las griferías de la cisterna ni Consulte a su fontanero por daños ocasionados por el uso de productos limpiadores de inodoros en el interior de la cisterna.
Página 12
Duravit AG Duravit USA, Inc. Duravit Shanghai Sales Center Werderstr. 36 2205 Northmont Parkway Suite B-d, 10/F Jiu Shi Tower 78132 Hornberg Suite 200 No. 28 Zhongshan Road South Germany Duluth, GA 30096 Shanghai P.C. 200010 Phone +49 78 33 70 0...