Led Brightness - Victron energy VE Bus Multi Manual

3. Using the VE.Bus Multi Control panel
The VBMC is used to remotely set the shore current, read out the status of your system and turn
on and off the Multis or Quattro's.
3.1 Turning the system on and off
Use the switch on the front to turn the system on, off or to charger only operation.
3.2 Setting the system input current limit
The shore current is set by the control knob on the VBMC. Turn the knob to the desired value.
There are 2 models of the VBMC: a 16 Amp and a 30 Amp. Use the appropriate panel for your
system.
When PowerAssist is enabled there is a minimum AC input current limit of approximately 2-3Amp
per device. Setting a lower limit than this minimum will result in the minimum limit. This is normal
Multi/Quattro behavior. There is a feature in the Multi/Quattro that, when PowerAssist is enabled
and the shore current setting from the remote panel is zero amps, the internal transfer relay is
opened and the device starts inverting.

3.3 LED brightness

For your comfort, the brightness of the LEDs is controlled automatically using a light sensor. When
the ambient light level becomes lower the LEDs will be less bright which is more pleasant for the
eye and reduces power consumption.
4