Technical Data; Special Safety Instructions - Grouw 18035 Manual De Instrucciones

SUBMERSIBLE PUMP FOR DIRTY AND CLEAN WATER
Introduction
To get the most out of your new submersible
pump, please read through these
instructions before use. We also recommend
that you save the instructions in case you
need to refer to them at a later date.
The submersible water pump is used for
pumping out water and other liquids from
garden ponds, pools, water butts, etc. and
can be used for draining fl ooded premises in
emergency situations.

Technical data

Voltage/frequency:
Power rating:
Capacity:
Max. pump depth:
Max. lifting height:
Particle size:
Automatic on/off with fl oat switch:
On:
Off :
Hose connector:
Connection:
*: 35 mm only when fi tting hose directly
to the submersible pump's thread (see
"Installation").
18
230 V ~ 50 Hz
550 W
10.500 l/hour
7 m
7 m
1/8/25/35* mm
max. 50 cm
min. 5 cm
¾", 1" and 1¼"
With 10 m rubber cable

Special safety instructions

The electrical connection must be protected
from water.
The pump must not be used for pumping
drinking water, salt water or fl ammable,
volatile, explosive, corrosive or abrasive
substances or liquids that are hazardous in
any other way.
Pumping very dirty or muddy water may
shorten the life of the pump.
The pump must not stand on the bottom if
there is a risk that there may be sludge or
mud on the bottom, as the pump's suction
inlet may become blocked.
The pump must not run empty.
The pump must not be exposed to frost.
Never insert your hand into the pump's
suction inlet when it is in use or is connected
to the mains.
Always check the cord and plug before using
the pump, as defective cords may cause
electrical leakage on contact with water,
producing an electric shock.
The submersible pump is a Category I
product, with earthing via the Schuko plug.