System Installation; Assembly; Main Control Board; Thermostat - Airzone UNO PACK Manual De Instalación

SYSTEM INSTALLATION

Before the Airzone system commissioning, please check:
•
The system is going to control works correctly without the Airzone system installed.
ES
In order to install properly your Airzone system, follow these steps:
Make all connections (see Sections Assembly and Connection).
EN
- Connect the thermostat.
- Connect the main control board to the unit to control.
FR
- If necessary, connect the inputs of the main control board to the desired devices.
- Power the main control board.
IT
Check all the assembly and the connection are correct (see section Assembly and connection evaluation).
Configure the system.
PT
If you have any other doubt, check the user manual.
DE
Access all our technical documents and the self-diagnosis section, check the most FAQs,

ASSEMBLY

MAIN CONTROL BOARD

The main control board is mounted on DIN rail or on wall. This main control board is externally powered at 110/230 Vac. It is
should be placed and mounted in accordance with the current electrotechnical regulations.
Note: To remove the main control board on DIN rail, pull the tab down to release it.

THERMOSTAT

UNO thermostats are mounted on the wall through a support. It is recommended not to locate it more than 40 meters away
from the main control board. To fix it to the wall, follow these steps:
• Separate the back part of the thermostat from the wall support.
• If your thermostat is wired make all the connections, if your thermostat is
wireless insert the CR2450 button battery.
•
Fix the back part of the thermostat to the wall.
•
Place the display on the support once it is fixed.
•
Place the anti-theft rods for additional support (optional).
16
certificates, watch our videos and read our declaration of conformity at:
myzone.airzone.es/products/