Plumbing Installation - Heatworks 1X Guía De Instalación Y Manual Del Usuario

5

PLUMBING INSTALLATION

Follow all plumbing instructions carefully. This product
MUST be installed by a licensed plumber in accordance
with all applicable national, state, provincial and local
plumbing codes.
STEPS
1) Flush the existing water lines to eliminate all
plumbing or plastic paste and residue caused by any
previous brazing or soldering.
2) Turn off the main water supply.
3) Connect the T&P relief valve to the MODEL 1X outlet
located on the top of the unit.
T&P Valve
MODEL 1X Outlet
For more information, please visit www.myheatworks.com.
Pressure Outlet
Domestic Hot
Water Outlet
Push
To Install
MODEL 1X Inlet
TYPICAL INSTALLATION
• Read label on provided T&P valve before
beginning installation.
• No valve may be placed between the relief valve
and water tank.
• To avoid water damage, discharge line must be run
to a safe place of disposal and must pitch downward.
• Do not install a shut-off valve, plug or cap in the
valve discharge line.
• Follow local codes where they vary from these
instructions.
4) Attach the threaded flexible water heater connection hose
to the domestic hot water outlet of the T&P relief valve.
5) Using the 3/4" push-fit flexible water heater
connection hose, attach the outlet from the tank heater
supply to the inlet of the MODEL 1X on the bottom of the unit.
HEATWORKS RECOMMENDS: Install a manual shut-off
valve (ball valve) on the inlet side of the MODEL 1X
Water Heater to provide a convenient shut-off point.
6) Turn on the main water supply.
7) Purge all air from the water lines and MODEL 1X by
opening a hot water demand source (hot faucet, shower,
etc.) Allow water to run though the water heater for at
least two to three minutes. Water from faucet will not be
hot at this point.
5