Control Panel; How To Use - Biochef BCB-1000 Manual Del Usario

Control Panel

Time Indicator
0000
On\Off Button
Speed Setting
Swipe panel
Pulse
Manual(BLENDER).indd 4
Pre set
Programes

How to use

1.ON/OFF Switch: Plug in the blender and place the blender container on the motor base,
all icons on the LED Display will light up. After the Machiene beeps for 1 second, the
blender will enter the Energy-Saving Mode.
The ON/OFF Key will flash in red light and all other icons on the LED Display will be
hidden from view. Touch the ON/OFF Key once, and the Preset Programs, Time Display
and Speed Setting Keys switch on. The Blender is now in stand-by mode and ready for
processing ingredients. If the blender is kept idle for 3 minutes, it will resume to the energy-
saving mode.
2.Preset Programs: When the blender is in stand-by mode, select the desired preset
program then press the ON/OFF Key to begin blending. The blender will operate according
to which program is selected. If at any time the blender needs to be stopped simply select
the ON/OFF icon and operation will stop and the Stand-By Mode will resume.
3.Speed Setting Swipe Panel: By Running your finger up the Swipe Panel, all bars below
the selected bar will light up to maximum brightness. Press the ON/OFF Key again and the
blender will begin processing at that selected speed. The ON/OFF Key will remain white
while the blender is operating at the selected speed. The Time Display will start counting
from "00.01".
When the blades have finished processing ingredients, press the ON/OFF Key again to
stop the operation. The maximum period for a single operation is 10 minutes. When the
operation reaches 10 minutes, the blender will automatically stop and resume the stand-by
mode.
4.Pulse Key: In stand-by mode or during operation press the pulse key once, the icon
flashes in 0.1 second intervals and the blender does not operate. Press and hold the pulse
key again and the blender operates in the fastest speed available. When the pulse key is
released the blender will resume stand-by mode.
11/07/14 1:39 PM