Preparing Coffee - Krups Crystal Arome Plus Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To replace the lid, put the front in place first
and then snap the back down into place.
Always place the glass carafe securely in
place with the handle facing out and
centered.
Inserting the "Duo Filter"
Remove the DuoFilter (b) from its plastic
bag. Rinse in tap water.
Open the hinged lid of the coffee maker and
remove the DuoFilter holder (a) (see fi-
gure 1).
Pivot the lower part of the holder and insert
the DuoFilter into its housing (see figure 2).
Replace the holder in the coffee maker and
your machine is now ready for use (see
figure 3).

Preparing coffee

Filling the water chamber
• Open the hinged lid. Using the glass carafe,
pour in the desired quantity of cold water.
(See figure 4). The water level indicator
shows how much water you are filling into
the container.
The amount of freshly brewed coffee
delivered after the brewing process will
always be slightly less than the amount put
into the water container. This is due to the
minimum absorption of the water by the
ground coffee. Therefore, it is
recommended that you add a little extra
water at the beginning so that you will have
the number of cups you desire.
Replace the glass carafe on the warming
plate with the lid in position. (See fi-
gure 5).
Putting in the ground coffee
With the hinged lid opened, insert a size 4
paper filter (KRUPS #983) or Gold Tone Filter
(KRUPS #026) into the the filter holder. You
can purchase KRUPS size 4 paper filters
(#983) or KRUPS Crystal Arome Gold Tone
Filter (#026) at your local KRUPS retailer or
by calling the KRUPS Consumer Service
Department at 1-800-526-5377, 24 hours a
day, 7 days a week.
We suggest using one level KRUPS
measuring scoop of ground cofee for each
cup of robust coffee. After using your
KRUPS coffee maker several times, you can
adjust the measure to suit your own taste.
Close the hinged lid, making sure that the
filter holder is securely in place.
Turn the machine on (g). An indicator light
will illuminate.
"Stop 'n Serve" feature
The "Stop' n Serve" feature is KRUPS answer
to the impatient coffee drinker's clamor for "a
quick cup of coffee!" This device
automatically stops the flow of brewed coffee
through the filter cone if the glass carafe is
removed from the warming plate during the
brewing cycle. You have about 20 seconds
between the removal of the carafe and its
being reinserted to pour one or two cups of
coffee. The "Stop'n Serve" device closes off
the filter cone so effectively that there is
virtually no coffee-drip onto the waming
plate. Once the carafe is replaced, the
brewing cycle and the flow of coffee into the
carafe are resumed.
If coffee does drip onto the warming
plate after removal of the carafe, it is
usually an indication that too much
ground coffee has been placed into the
paper filter. This causes the water that
jets into the filter cone to overflow
between the paper filter and the sides
of the filter cone. The overflow carries
coffee grounds that interfere with the
snapshut action of the filter holder, thus
allowing brewed coffee to continue to
drip through.
If this blockage and subsequent dripping
do occur, replace the glass carafe
immediately and allow the full brewing
cycle to brewing cycle to run its course,
Do not remove the filter until the
brewing cycle is completed.
Preparing "wake-Up" coffee (model #467)
This feature enables you to enjoy freshly
brewed coffee at any pre-selected time within
a 24-hour period.
• First set the digital clock (see "Setting the
time")
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Crystal arome plus time466467

Tabla de contenido