Gree GCF220BKNA Manual Del Usuario página 11

Warning
Before fi lling water, cleaning product or maintenance, the appliance must be
disconnected from the supply mains or unplug the power supply.
4.Preparation of Water Tank
The air cleaning function is available even
without water in the tank.
1.Take out water tank and remove the cap.
2.Fill water into water tank and screw cap up.
Notice:
Don't use the below water
● Water exceeding 40℃ or with aromatic solvent oil,
chemicals, aromatics or abluent (which may cause
deformation or malfunction);
● Water from water clarifi er, basic ion water with
basic ion, water with mineral substance or water
from well (which may multiply mildew or bacteria);
● Fill water in a proper place;
● Fill a little of water into tank fi rstly and then shake
it for cleaning. After that, fi ll clean water to tank.
Make sure that cap of water tank has been
screwed up otherwise water will leak.
● Please hold the handle of water tank tightly when
moving the water tank which has been fi lled with
water.
● Don't touch the valve in the middle of cap
otherwise water will leak.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Press button
"PUSH" and take
out water tank.
Water tank
3.Install water tank
● Hold the handle and insert water tray into water
tank. Then install water tank in the unit.
Water tank
Water tray
Notice:
● When changing water, pour out water
remaining in water tray, otherwise, fouling or
odor will be produced.
5. Insert attaching plug into
the socket
Socket
● Sensitivity of odor sensor is determined within
2 minutes after plugging in. Therefore, insert
attaching plug when there is no odor.
6. Prepare remote control
1.Prepare remote control
Open the battery cover
on the back of the remote
control, place the battery
in the circular tank, pay
attention to positive and
negative poles, plug back
the remote control and
then it can be used.
2.Use the remote control
● Please put the remote control pointing to the
receiver window in operation.
● The remote control should be used in the effective
range.
● Make sure there is no obstruction between the
remote control and air cleaner, otherwise it will
affect the signal transduction.
9
If hearing "click" sound, it
means water tray has been
inserted correctly.
Attaching plug
3
1
Battery
2
4