Buttons Function Introduction - Gree GCF220BKNA Manual Del Usuario

Buttons Function Introduction

ON/OFF
For turning on or turning off the unit. Press
this button once to turn on the unit and
press it again to turn off the unit.
FAN
Adjust fan speed of the unit and the
sequence of fan speed is:
Silence → Low → Med. → High
↑
HUMIDIFY
Press this button to turn on humidify mode.
LED lamp for humidify mode will be on.
Press this button again to cancel humidify
function and LED lamp for humidify will be
off; In humidify mode, press button "+ "or "–
to adjust set humidity.
Note: only when the set humidity is 10%
higher than ambient humidity, the unit can
start humidification function.
AUTO
Press auto button to enter auto mode.
LED lamp for auto mode will be on and
other functions will quit. Based on air
quality sensed by sensor, the unit will
automatically adjust function and fan
speed of the unit. Press this button again
to cancel auto mode and LED lamp will be
off.
SLEEP
Press this button to enter sleep mode.
LED lamp for sleep will be on and other
functions will quit. Based on air quality
sensed by sensor, the unit will be
automatically adjusted. Press this button
again to cancel sleep mode and LED lamp
for sleep mode will be off.
TIMER
When the unit is turned on, press timer
button to activate timer off and the LED
lamp for timer will be on. Press button + or
– to set time for turning off the unit. When
pressing timer button again, LED lamp for
timer will be off and timer will be canceled.
In standby status, press timer button to
activate timer on and LED lamp for timer
will be on. Press button + or – to set time
for turning on the unit. When pressing timer
button again, LED lamp for timer will be off
and timer will be canceled.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
Press this button and plasma and anion
will change as follows:
Plasma is on
Anion is off
ELECTROSTATIC
Press button of electrostatic dust removal to
activate dust removal function and LED lamp
for dust removal will be on. (This button is
not available for model GCF220BKNA.)
"
In humidify mode, it is used for setting
humidity; in timer mode, it is used for setting
timer.
+
(Refer to page 11 for more details.)
+
(Refer to page 11 for more details.)
+
When the unit operates and child lock is off,
press auto and timer buttons simultaneously
for 2 seconds to turn on or turn off nixie tube
and LED lamps on front panel.
+
When the unit is in standby mode and child lock is
off, press sleep and timer buttons simultaneously
to clear time of timing counter.
1. When accumulated time for cleaning and
replacing lter doesn't reach, they will be cleared
after resetting time.
2. when one kind of accumulated time reaches,
it will be cleared by resetting time. And the other
one will keep accumulating time.
3. When both of them are reached, they will be
cleared after resetting time. After clearing, LED
lamps on front panel will be on for 2 seconds.
12
PLASMA/ ANION
Plasma is off
Plasma is off
Anion is on
Anion is off
+/-
Buttons for adjusting
sensitivity degree of dust.
Buttons for adjusting
sensitivity degree of odor.
Buttons for light
Buttons for resetting time