Kenmore 95683 Manual De Uso Y Cuidado página 5

Compacto refrigerador 3.1 cu. ft.
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Door
Reversal
CAUTION : To avoid injury to yourself and/or
property,
we recommend
someone assist you during the door reversal process.
1,To access lower hinge, tilt back the refrigerator
cabinet
(Avoid
tilting the refrigerator
45 degrees).
2, Remove left adjustable
leg located at the front of the cabinet
(Fig.A).
3, Remove the screws holding the lower hinge to the cabinet
(Fig.A).
4, Remove the lower door from the refrigerator
cabinet
(open
door and pull down).
5, Remove the screws from the middle hinge, then remove the
middle hinge and upper door
(open door and pull down).
6, Remove the upper hinge (Fig.C).
NOTE: Be careful to retain all gaskets and washers in
position when removing and reinstalling
hinges.
7,,Re-install the upper hinge on the opposite side of the cabinet
(Fig.C).
8, Remove the door plugs located
on the top of each door.
9, Re-fit the door plugs on the opposite
sides of both doors.
10, Re-install the upper door on cabinet
11,Remove the middle hinge plugs from the divider panel
between
the upper and lower compartment
(Fig.B).
Re-fit plugs on opposite side of panel. Re-install middle hinge
using holes exposed from removal of plugs.
12, Re-install the lower door on cabinet.
13, Re-install the lower hinge on the opposite
side of cabinet base.
14, Re-install the adjustable
leg to the opposite side of cabinet.
15, Make sure the doors are properly
aligned on the cabinet
before
tightening the screws.
The process is now complete.
8
Initial Use
To reach the set coldness level when operating
the refrigerator
for the first time, run it without food
load until you hear the compressor
stop. This usually takes 2 to 3 hours. Once the set temperature
is
reached, load food into the refrigerator.
Note:
If the refrigerator
has been
placed
in a horizontal
or
tilted position for any period of time, wait 24 hours before plugging it in.
Temperature
Control
The first time you turn the unit on, adjust the temperature
control knob to 3 and
give your refrigerator
time to cool down completely
before adding food; a full
OFF
Cod_,
....
.
Cdd
24 hours is recommended.
After it is fully cooled,
test it and adjust towards
1to
/'_
_,
make less cool or towards 6 to cool more to best suit your needs.
_/
_
,Jo
Note: Turning the temperature control knob to the OFF position will stop the
cooling cycle but does not shut off power to the unit.
Defrosting
Your Refrigerator
For maximum energy efficiency,
defrost freezer section whenever
frost accumulates to a thickness of
1/8" or more on freezer watts. Note that frost tends to accumulate more during the summer months.
To defrost freezer, remove food and ice cube tray from the freezer section. To defrost, turn the
temperature
control dial to the "Off"
position.
Defrosting may take a few hours. To speed up defrost time, keep the door open and place a bowl
of warm water in the refrigerator.
You may now reset your refrigerator
to the desired temperature and return food.
ii
iii
Normal
Operating
Sounds You May
Hear
Boiling water, gurgting sounds or slight vibrations that are the result of the refrigerant
circulating
through the cooling colts.
The thermostat
control will click when it cycles on and off.
6/8/10

Publicidad

Tabla de contenido
loading

Tabla de contenido