Operation; Operating The Fan - HAMPTON BAY CAMPBELL 51350 Guía De Uso Y Mantenimiento

Operating Your Fan and Remote Control
Remote Control - Your fan is equipped with a remote control to operate
the speed and lights of your new ceiling fan.
Speed setting for warm or cool weather depends on factors such as
the room size, ceiling height, number of fans and so on.
The fan is shipped from the factory with the reversing switch
positioned to circulate air downward. If airflow is desired in the
opposite direction, turn your fan off and wait for the blades to stop
turning, then slide the reversing switch (located in switch cup) to the
opposite position, and turn the fan on again. The fan blades will turn in
the opposite direction and reverse airfow.
NOTE: Wait for the fan to stop before reversing the direction of the
blade rotation.
Warm weather - (Forward) A downward airflow creates a cooling effect.
This allows you to set your air conditioner on a higher setting without
affecting your comfort.
Cool weather - (Reverse) An upward airflow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.
Transmitter operation
NOTE: This remote is equipped with a 16-code
combination. To prevent possible interference from or
to other remote units such as garage door openers,
car alarm or security system, change the combination
code but be sure that the code on both the hand held
transmitter and receiver in the fan are the same.
Install a 12-V battery (included).

Operating the fan

3 button = High speed
2 button = Medium speed
1 button = Low speed
Power button (UU) = Power off
Light button (V V) = Press and release immediately to turn the
light on or off
Dimmer function = Press and hold light button (V V) to dim or
brighten bulbs to the desired level then release light button
(for tungsten bulbs only)
12
UU
V V