Setting The Clock - Sangean PR-D7 Instrucciones De Manejo

Using the supplied AC power adaptor
The supplied AC adaptor is 12 Volts DC output 500 mA center
pin positive.
1. Insert the adaptor plug into the DC IN socket on the left hand
side of the radio.
2. Plug the adaptor into a standard 13A mains socket outlet.
Whenever the adaptor is plugged into the radio and switched on
the mains, the batteries are automatically disconnected.
If the adaptor is plugged into the radio but not the mains is not
switched on then the radio will run from the batteries if fitted.
The AC adaptor should be disconnected from the mains supply and
the radio when not is use.

Setting the clock

1. Clock can be set either the radio is power on or off.
2. Display will show " - : - - " when the batteries are installed when
the radio is connected to the mains supply.
3. Press and hold the
display will flash time set symbol
followed by a beep.
4. Press Tuning Up/Down to set required hour.
5. Press button again, the minute digits will flash.
6. Press Tuning Up/Down to set required minute.
7. Press button to complete time setting.
7
button for more than 2 seconds,
and also the hour digit,