Setting The Clock Manually - Sangean TunPad DPR-202BT Instrucciones De Manejo

Note:
1. NFC connectivity performance may vary depending on the connected Bluetooth
devices. Please refer to the Bluetooth capabilities of your device before connecting
to your radio. All features may not be supported on some Bluetooth/NFC enabled
devices.
2. The location of the NFC detection area is not the same on all devices. When
connecting with other Bluetooth device via NFC, refer to the User guide of the other
device for more information.
3. Some of metallic case or cover for mobile phones may reduce the sensitivity of NFC.
Make sure you remove it, before activating the NFC.
Disconnecting your NFC-enabled device
To disconnect your device, simply touch directly against the radio's tag again on the
right panel. The Bluetooth status indicator on the front panel flashes blue to show the
radio is discoverable.
Automatically updating the clock
1. Press the Power button to switch on your radio.
2. Press and hold the Menu button until the Advanced menu of the current mode shows
on the display.
3. Press the Tuning up/down until 'System ' appears on the display. Then press the
Select button to enter the setting menu.
4. Press the Tuning up/down until 'Time' appears on the display. Then press the Select
button to enter the setting menu.
5. Press the Tuning up/down until 'Auto update' appears on the display. Then press the
Select button to enter the setting menu.
6. Press the Tuning up/down button to choose an update option from 'Update from Any',
'Update from DAB', Update from FM' or 'No update' as required. The current update
option will be marked with an asterisk. Press the Select button to confirm your choice.
The radio will return to the previous menu.
Note:
If you select 'Update from Any', 'Update from DAB', Update from FM' the current time
received will be displayed. If no signal is found you should either position the radio or its
antenna so that a signal can be received, or revert to manual clock mode.

Setting the clock manually

Your radio will set its clock automatically using the DAB or FM radio signal. If no signal
is available and you need to set the time manually, please follow the procedure shown
below. Please note that the clock time can be set manually only when the radio is on.
1. Press and hold the Menu button until the Advanced menu of the current mode shows
on the display.
2. Press the Tuning up/down button until "System" appears on the display. Then press
the Select button to enter the menu setting.
3. Press the Tuning up/down button until "Time" shows on the display. Then press the
Select button to enter the setting menu.
4. Press the Tuning up/down button until "Set Time/Date" appears on the display. Then
press the Tuning up/down button to enter the setting.
GB
13