60653-01 10U100 UserGuide_r2
trouble
6
P R O B L E M
The remote
does not ring
I cannot hear
a dial tone
5/11/01
12:12 AM
s h o o t i n g
I T E M S T O C H E C K
• Make sure that the Ringer
• Ensure that the Telephone Cord
Adapter
are installed correctly.
• Recharge the Remote Battery
the Remote Charging Well
• Disconnect the AC Adapter from the power source and
reconnect it in a known good outlet.
• Use the Remote
in an area closer to the Base
• Make sure your Remote Rechargeable Battery
securely seated in the Charging Well
charged. The Battery may need to be charged for
8 hours prior to first use.
• Check that all cords are correctly connected and firmly
in place.
• Adjust the Dual Function Receive Volume Control
up to increase the volume.
• Make sure the Remote is within range of the Base.
• Separate and then reconnect the Rechargeable Battery
and Remote
.
• Return the Remote to the Charging Well
to re-establish a communication link.
20
Page 20
E N G L I S H
is "On".
and the AC
by firmly placing it in
.
.
is
and/or fully
Key
for 5 seconds