Erreka ROLLER V-II Manual Del Usuario página 17

ACCESS TO THE ROLLER CONSOLE
The ROLLER V-II console is fitted with an on/off switch on its right-hand
side and connectors on the front, duly indicated for inserting the transmitter
and memory recording cable.
The console is powered by one or two 9-volt alkaline batteries housed in
the battery holder located on the bottom of the console. The batteries
must be replaced when a lack of contrast is noticed in the letters on the
display.
Connect the console by pressing the red button located on the right and
the following logo will appear
AUTOMATISMOS
The console will remain in this state until ENTER is pressed and the six-
figure access code is requested.
ACCESS CODE
* * * * *
If the code is incorrect, CODE ERROR will appear and after pressing ENTER
the access code will be re-requested.
If the access code is correct, CODE OK will appear and pressing ENTER will
lead to the menu, which will appear on the screen and can be moved
around using the UP and DOWN arrows located in the central columns of
row 4 of the keypad, the menu selected being activated when in upper
case letters.
1.- ENCODE TRANSMITTER
2.- Encode memory
3.- Display memory
4.- Copy memory
5.- Replace transmitter
6.- Change access code
7.- See transmitter code
8.- See memory code
1.- ENCODE TRANSMITTER
This option allows us to personalise standard ROLLER transmitters or
previously personalised transmitters for another subsequent installation
with a matching installer code.
This option can be entered when it appears in the menu in upper case
letters and ENTER is pressed, leading to the 4-figure installer number for
which transmitters are to be personalised being requested
INSTALL. NO
* * * *
By pressing ENTER again, the edited installation no. is validated to avoid
personalising transmitters with a badly entered code by mistake.
INSTALL. NO .
VALIDATE ENT/ESC
ERREKA
* * * *
17
English