Erreka ROLLER V-II Manual Del Usuario página 23

CODE XXXXXXX/YYYY
VALIDATE ENT/ESC
If Escape is pressed, the menu is directly accessed. If Enter is pressed, the
replacement number between 1 and 7, inclusive, is requested.
REPLACEMENT NO.
When Enter is pressed again, the following is indicated.
REPLACEMENT NO. X
INSERT TRANSMITTER
Waiting for the insertion of a transmitter and for Enter to be pressed to
begin recording and Escape to return to the menu.
If the encoding has been completed correctly, the following will be displayed:
ENCODING OK
If the encoding has failed, the following error will be displayed:
ENCODING ERROR
N.B.-
This process can be carried out as many times as required with standard
transmitters or those with the installer code.
It is wise for the records to be displayed through the function SEE
TRANSMITTER CODE to ensure no errors have been made when entering
the transmitter and replacement code data.
6.- CHANGE ACCESS CODE
This option is necessary to personalise installations with a maximum security
level, given that the installer code is changed with the access code.
It is also possible to personalise access to the console and maintain the
standard ROLLER code by changing only the first two figures of the access
code and leaving the remainder at value 9999.
To enter this option, CHANGE ACCESS CODE must appear in upper case
letters and ENTER pressed.
The console will request a new access code.
NEW ACCESS CODE
* * * * *
Once the new code has been entered, press ENTER and re-enter the code
to avoid errors.
REPEAT ACCESS CODE
* * * * *
If the code entered the second time does not coincide with the first, the
console will request a new access code. If, however, the code matches the
first, it will be retained for future use and the menu will be directly accessed.
It is important to note down the code entered in the console on a piece
of paper or in a safe place, given that if it were lost the only solution
would be to replace the chip inside the console.
If this option has been entered by mistake and the access code is not to
23
English