Installing The Batteries - Silverline 727787 Manual De Uso

GB
Maximum measuring range: ............................................................. 0.2–40m
Measuring accuracy:................................................................± 1.5mm
Measuring units: ...................................................................................Metres
Laser class: .......................................................................................... Class 2
Laser wavelength:. ................................................................... 650nm, ≤1mW
Power supply: .........................................2 x AAA 1.5V batteries (not included)
Operating temperature:................ .............................................0°C–40°C
Storage temperature: ................................................................... -10°C–60°C
Auto laser off: .................................................................................30 seconds
Auto power off: ............................................................................180 seconds
Laser Safety
The laser used in this device is a Class 2 laser with maximum power of ≤1mW and a
wavelength of 650nm.
These lasers do not normally present an optical hazard, although staring at the beam may
cause flash blindness.
WARNING: Avoid direct eye contact.
A hazard may exist if you deliberately stare into the beam, please observe all safety rules
as follows:
• The laser shall be used and maintained in accordance with the manufacturer's
instructions
• Never aim the beam at any person, and particularly not into the eyes of any person or
animal, or any object other than the workpiece
• Always ensure the laser beam is aimed at a sturdy workpiece without reflective
surfaces. i.e. wood or rough-coated surfaces are acceptable. Reflective sheet steel
or similar is not suitable for laser use as the reflective surface could direct the beam
back at the operator
• Do not change the laser light assembly. Repairs must only be carried out by the laser
manufacturer or an authorised agent. DO NOT exchange with a different type of laser
CAUTION: Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
Please refer to the relevant EN standards, EN61326-1:2013 for more information
on Lasers.
Product Familiarisation
Meter:
1 Laser/Sensor
2 LCD Screen
3 Laser/Measurement Button
4
Area/Indirect Measurement Button
5 Measure Reference Point Button
6 ON/OFF/Clear Button
7
Backing Clip Release Button
8 Backing Clip
9
Battery Insert
LCD Screen (2) breakdown:
A
Battery Charge Level
B Historical Memory
C
Value 1
D Value 2 / Minimum Value
E Value 3 / Maximum Value
F Summary Line / Calculation Result / Latest Value
4
Specification
Original Instructions
G Measuring Mode Indicator
H Setting
I Continuous / Distance Measurement
J Base Reference Point Setting
K Top Reference Point Setting
L Laser ON / OFF
Intended use
Battery-powered device for measuring distance up to 40m with additional functions for
calculating surface area, volume, and Pythagoras triangle calculations.
Before Use
Installing/removing the backing clip
7
8
8
9
( Fig. I )

Installing the batteries

1. Remove the Backing Clip (8) to reveal the Battery Insert (9)
2. Press the tab and pull the Battery Insert cover out
3. Insert the 2 x AAA 1.5V batteries, matching the '+' and '-' terminals correctly (See Fig. II)
4. Reinstall the Battery Insert cover, then the Backing Clip
Operation
WARNING: This product emits a laser beam. Do not stare into the laser beam and
never point this product at another person.
Switching ON/OFF
Note: This device will automatically switch off after 180 seconds when not in use. If this
happens, switch back on to continue usage.
Note: This device's laser will automatically switch off after 30 seconds when not in use.
Switching ON
• Press and hold the ON/OFF/Clear Button (6) until the LCD Screen (2) is illuminated
• The meter is ready to use
Switching OFF
• When the meter is on, press and hold the ON/OFF/Clear Button (6) until the device
switches OFF and the LCD Screen (2) becomes blank
9
( Fig. I|)