Chest Belt Application; Hipclip Application - Sigma RC 1209 Manual De Uso

4 OVERVIEW

4.1.1 CHEST BELT APPLICATION

4.1.2 HIPCLIP APPLICATION

40
Press the R3 transmitter into the snaps of the chest
belt.
Important: Detach the R3 transmitter from the belt
after training in order to save the battery. The transmitter
always becomes active if a current flows between the
two contacts. This is the case when the chest belt is
worn on the skin, or if the chest strap and/or the R3
transmitter lies, for instance, on a wet towel. When the
LED flashes, the R3 transmitter is on.
Adjust the length of the belt.
Important: The belt should fit snug, but not too tight.
Place the belt below the chest muscle or breasts.
Important: The R3 transmitter faces forward.
Wet the surface of the sensor, which rests on the skin.
Important: The heart rate measurement is reliable only
if the sensor surface is moist.
Note: sensors are the two silicone pads to the left and
right of the removable R3 transmitter.
Snap the R3 transmitter into the HipClip.
Important: Detach the R3 transmitter from the HipClip
after training in order to save the battery. The transmitter
becomes active when it is clipped on the HipClip or if
current can flow between the contacts (press buttons).
When the LED flashes, the R3 transmitter is on.
Note: The R3 transmitter can be used only in one
direction.
www.sigmasport.com