Incidents During Sawing; Motor Belt Tension; Important Recommendations - Husqvarna FS 400 LV Manual De Explicaciones

Emergency stop (electric motor) :
Press the red knob (circuit breaker).
9 – INCIDENTS DURING SAWING
Several causes can result in the blade stopping in the
sawing groove or the machine stopping:
!"
Tension of the belt.
!"
Lack of fuel.
!"
Excessively fast feed or descent, etc.
!"
In all cases remove the blade from the groove
and check the machine thoroughly.
Entrust repairs to authorised dealer
only.
10 – MAINTENANCE
"Engine Maintenance" : refer to the
engine maintenance booklet.
!"
After use, clean the machine.
!"
Lubrication: apply a moderate amount of bearing
lubricant to the nipples in the depth adjustment
chassis (depending on the frequency of use).
!"
The spindle bearings must be greased after 8
hours of use, with a grease gun by pumping three
to five times the grease into the greaser of the
bearings. Only use a Super lithium 12 based
grease in compliance with the NLG1 GRADE 2
consistency.
!"
Every 40 hours grease : depth control adjustment
screw.
!"
Check ENGINE OIL daily. Read engine owners
manual for O I L and OIL FILTER change
intervals. Use :
SAE 10W30 motor oil with API class
o
MS, SD, SE or better for PETROL
engines.
API class CD or CE for Hatz diesel.
o
Dispose of the old oil as laid down by
the regulations in force.
To empty the motor, place a funnel at the drain outlet
(V) [FIG. 3].
AIR FILTER :
OIL
!"
Read engine owners manual for maintenance
intervals. For extremely dusty conditions you may
have to clean the air filter element 2 to 3 times a
day.
!"
Replace any damaged filters or gaskets.
Store in a safe place out ot reach of
children.
Remove all adjustment tools and
wrenches.
Store diamond tool in a safe place so
it cannot be bent or damaged.
11 – MOTOR BELT TENSION
After several hours of use it may be necessary to
adjust the tension of the belts (moderately). To do this
proceed as follows :
!"
Release the screws fixing the motor to the
chassis.
!"
Turn the tensioning screw (N) at the front of the
machine one quarter turn; this screw pushes the
motor backwards [FIG. 6].
!"
At normal tension, counterlock the nut of the
screw (N).
!"
Relock the motor fixing screws.
Never
tension.
12 – IMPORTANT RECOMMENDATIONS
!"
Periodically tighten all nuts and bolts, particularly
after the first few hours of operation.
!"
Check the tension of the belt. Tighten it, as
instructed.
!"
When storing the machine, we recommend
removing the blade and storing it carefully.
!"
Check that the blade is properly sprayed by
inspecting the holes in the fork regularly.
!"
Tighten the blade firmly.
!"
Make sure the contact faces of flanges, blade
and axle are clean.
The
responsibility for loss or damage
resulting
modification, alteration or powering
that
manufacturer's original specifications.
English - 5/6
set belts beyond
manufacturer declines
from misuse
does not conform
original
all
or any
to the