Maintenance And Cleaning - Oase StreamMax Pump Controller Instrucciones De Uso

- EN -
Operating mode and configuration mode
Operating mode
Switch off both flow pumps. After switching on the
unit, this mode is automatically activated.
Feeding. The speed of both flow pumps changes to 0 or
10 % for 3 minutes. (→ Configuring the "feeding"
mode)
Specify speed in % for the flow pumps on P1 and P2.
0-100 Increment: 10 %.
Specify speed in % for the flow pumps on P1.
0-100 Increment: 10 %.
Specify speed in % for the flow pumps on P2.
0-100 Increment: 10 %.
Specify pre-defined flow profile.
Configuration mode
Determine flow pump on P1 and P2.
No flow pump
StreamMax Premium 2000
StreamMax Premium 4000
StreamMax Premium 5000
Speed of the two flow pumps during feeding.
Speed 0
Speed 10 %
Reset error message.
Restore factory settings.
Specifying the speed
A constant speed is set for the flow pumps in the
operating modes ALL, P1, P2. In the operating mode
SCE, one of 18 pre-defined flow profiles with variable
speeds can be selected.
·
Flow profile overview
How to proceed:
1. Select the desired operating mode and confirm
with "OK".
2. Select the desired speed value or flow profile and
confirm with "OK".
– The display will flash for approx. 10 s.
12
Configuring connections P1 and P2
For operation, the connections P1 and P2 must be
adapted to the flow pump in use. Operation is only
possible, if the setting is correct.
How to proceed:
1. Select the configuration mode and confirm with
"OK".
2. Select P1- or P2- and confirm with "OK".
3. Select the respective setting for the connected
flow pump and confirm with "OK".
4. If necessary, configure the second connection.
Configuring the "feeding" mode
The flow pumps are switched off for 3 minutes or run
at minimum speed.
How to proceed:
1. Select the configuration mode and confirm with
"OK".
2. Select and confirm with "OK".
3. Select the desired speed and confirm with "OK".

MAINTENANCE AND CLEANING

Cleaning the device
· Wipe the device with a damp cloth.
Reset error
In the event of a malfunction, the unit switches off
the pumps. The display alternates between Err and
the error number, e.g. 001. (→ Error messages)
How to proceed:
1. Press the "OK" button.
– The error message has been reset.
2. Eliminate malfunction.
Restoring the factory default settings
Restoring the factory settings deletes all individual
settings.
How to proceed:
1. Select the configuration mode and confirm with
"OK".
2. Select def and confirm with "OK".
– The factory setting has been restored.
– The unit changes to operating mode OFF.
StreamMax Pump Controller