Installation And Connection - Oase PondoVac Premium Instrucciones De Uso

4

Installation and connection

 B, C
W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
Set up the unit at least 2 m away from the pond/pool.
►
Ensure that the ground under the unit is firm and horizontal so that the unit cannot tip over.
►
Apply the parking brake to prevent the unit from moving during operation.
►
Adhere to national and regional regulations.
►
N O T E
Only set up and operate the unit in a position that is higher than the level of the water. Possible
consequences if the unit is operated in a position that is lower than the level of the water:
Water will automatically flow into the tank. This will negatively affect the suction mode.
►
When the unit is switched off, water will automatically flow through the tank. The pond/pool will be
►
emptied.
N O T E
Transport and installation of the unit
Transport the unit on its own wheels.
►
Do not lift the unit by its handle.
►
The unit weighs more than 40 kg. Use a suitable carrying aid for lifting the unit.
►
The following conditions must be met:
Allow the dirty water to drain out into a drain or far enough away from the pond to ensure that it cannot
•
flow back into the pond.
Completely unwind the power and extension cable.
•
– Ensure that the cables are not bundled together or coiled up.
Connect the discharge hose and floating suction hose as well as the Oase nozzles.
•
– Recommendation: Use a bend-resistant discharge hose for the first 10 metres. A bend-resistant hose
allows unrestricted flow of the dirty water.
- EN -
23