Clearwave Disassembly And Cleaning; Replacing The Aerator Stone; Storage/Overwintering - Oase ProfiClear Premium XL Discharge Module Instrucciones De Uso

7.2

ClearWave disassembly and cleaning

(Only pump-fed ProfiClear Premium XL drain module)
The ClearWave filter elements generally do not need to be cleaned. When the container is cleaned,
the filter elements can be removed and hosed off with a powerful water jet.
How to proceed:
 F
1. Remove the cap nuts M6 on both sides in the container and remove the holders.
2. Remove the ClearWave filter elements.
3. Reinstall the ClearWave filter elements in the reverse order.
– When inserting the filter elements, ensure that they are correctly positioned in the holders at the
bottom of the container.
7.3

Replacing the aerator stone

(Only pump-fed ProfiClear Premium XL drain module)
Preparatory work:
• Dismantle ClearWave. (→ ClearWave disassembly and cleaning)
How to proceed:
 G
1. Pull the aerator stone out of the clamping holder.
2. Disconnect the hose from the aerator stone and connect it to the new aerator stone.
– Fasten the connecting hose with a hose clip.
3. Push the aerator stone back into the clamping holder.
8

Storage/overwintering

Decommissioning depends on whether or not the unit is protected against freezing.
The unit is protected from frost (e.g. stored in a garage or other enclosure)
The unit can be operated as long as the water temperature does not go below +4 °C.
The unit is not protected from frost (e.g. outdoor installation)
Take the unit out of operation at water temperatures below +8° C or, at the latest, when freezing
temperatures are to be expected.
• Drain the unit as far as possible, clean thoroughly and check for damage.
• Empty all hoses, pipes and connections as far as possible.
• Leave the slide valves open.
• Cover the container so that no rain water can enter.
• Protect pipes and slide valves that are in contact with water from frost.
- EN -
25