Oase ProMax Pressure Cistern 6000/6 Instrucciones De Uso página 15

Vertical installation of the pump with
the stand
The pump can be vertically installed with
the stand in a tank or well.
• Ensure that the screen on the suction
side is at least 150 mm below the sur-
face of the water.
• If the water contains sand and/or is
soiled, install the pump in a raised posi-
tion or use ProMax Floating Intake
(57772).
How to proceed:
 D
1. Push the mounting feet onto the stand.
2. Undo the Allen screws until the opening
of the stand is wide enough to fit onto
the pump.
3. Push the pump into the stand.
4. Tighten the Allen screws until the pump
is fixed in the stand.
OPERATION
When the water level rises, it lifts the float
switch until the switch-on point is reached
and the pump switches on.
When the water level drops, the float
switch lowers until the switch-off point is
reached and the pump switches off.
• The integrated non-return valve pre-
vents water from flowing back into the
pump from the pressure hose when it is
switched off. The non-return valve also
prevents damage to the pump resulting
from water hammer.
Automatic mode
The use of OASE ProMax Garden Auto-
matic Switch allows automatic operation.
When the connected appliance (water
withdrawal) is opened, the pump switches
on; when it is closed, the pump is switched
off.
• The float switch of the pump serves as
dry run protection. If there is not suffi-
cient water, the float switch automati-
cally switches off the pump.
Starting up the pump
W A R N I N G
Dangerous electrical voltage!
Death or severe injury from electrocu-
tion.
• Only connect the pump to the power
supply when there are no persons in or
reaching into the water.
• Before stepping into or reaching into the
water, switch off all units located in the
water.
• Insert the power plug into the socket.
– The pump is ready for operation.
– The pump will start up as soon as the
level of the water reaches the switch-
on height.
N O T E
If the water contains a large quantity of
suspended sand (e.g. in the case of a
new well), allow the pump to run at full
flow rate for approx. 1 hour without inter-
ruption in order to pump out the water
containing the sand. Otherwise the non-
return valve could become blocked by
sand being deposited in the pressure
line.
Taking the pump out of operation
• Disconnect the power plug.
DE
EN
FR
NL
ES
PT
IT
DA
NO
SV
FI
HU
PL
CS
SK
SL
HR
RO
BG
UK
RU
CN
15