Preparing The Boiler; Starting Up; Limit Of Waranty - CHAFFOTEAUX CKZ Instrucciones De Instalacion Y Uso

preparing the boiler

STARTING UP

Fill the appliance
• Check the water pressure using the pressure gauge. This should be
a minimum of 1 bar when cold and a maximum of 6 bar when hot.
• Check that the primary tank is completely purged.
• Check the sealing of the connectors on the primary tank.
LIMIT OF WARRANTY
The warranty is only valid if a qualified technician carries out the ins-
tallation.
The warranty does not cover faults due to:
abnormal environmental conditions:
• Positioning in a location that is affected by freezing or bad
weather.
• Supply using rainwater, well water or water which is highly
aggressive and
national regulations and applicable standards.
• The warranty only covers the replacement or repair of appliances
and components
acknowledged to be
necessary, the part or product must be returned to one
of our factories, but only with prior authorisation from our
technical services.
and travel costs
The replacement or repair of an appliance component does
not entail a right to compensation.
• Damaged caused by impacts or falling during handling following
delivery from the factory. In particular, water damage which
could have been avoided by carrying out immediate repairs to the
appliance.
not compliant
which we
defective at origin.
Labour, freight, packaging
are payable by the
The warranty only applies to the appliances and their components
and excludes all or part of the appliance's electrical or hydraulic sys-
tems.
An installation that does not conform to regulations, current
national standards and best industry practice.
In particular:
• Safety unit absent or incorrectly installed.
• Installation of a safety unit which does not conform to applicable
national standards and use of a second-hand safety unit
on a newly installed appliance.
• Modifying the safety unit settings after breaching the
seal.
• Abnormal corrosion due to incorrect hydraulic connection
(direct iron/copper contact).
with
Insufficient maintenance:
• Failure to maintain the safety unit, resulting in over-
pressure.
have
• Jacket subjected to external abuse.
If
• Modifying original equipment without the manufacturer's
permission or using spare parts not recommended by the
manufacturer.
user.
GB
33