Mounting Instructions; Wiring Diagram - position C2RLC Manual De Instalación

INSTALLATION MANUAL
C2RLC - C2RLCE
Stainless Steel Keypads - Self contained

4] MOUNTING INSTRUCTIONS

1
Take the dimensions of the flush mount casing and make
a cavity provision in the wall. Refer to the wiring diagram
to drill the hole access area. Mount the flush casing
(Optional: flush mount box not included - Sold separately)
in the wall cavity Complete the wiring on the keypad
and mount the C2RLCE with the screws.

5] WIRING DIAGRAM

Red and Green LED's:
The red and green LED's give the status, as default,
of the C2R LC keypad. It is possible to control
these LED's by another device, just cut the straps
and connect the wires of the LED's.
Wire colors Description
Yellow 0V
Green +12V
White 0V
Red +12V
WIRING TABLE
Terminals Description
+ +12V dc input voltage
- - 0V input voltage
1 1 Tamper switch output
2 2 Tamper switch output
3 3 Request-To-Exit input for relay 1
NO Contact relay 1
C1 Common relay 1
NC Contact relay 1
NO Contact relay 2
C2 Common relay 2
NC Contact relay 2
Not included
Input voltage
230V
Alarm
230V
Input voltage
2
Place the surface housing on the wall then mark with a pen
the hole location then drill the mounting holes and the
hole wiring access. Mount the housing on the wall. Wire
the cable on the terminals and then mount the C2RLC
on the surface housing.
gREEN RED
LED LED
ST1, ST2, ST3
et ST4 = LED's Straps
12V dc
Varistor
BP
Lock
fail secure
12V dc
EN
gREEN RED
LED LED
3
position.eu.com