Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION MANUAL
C2RLC - C2RLCE
Stainless Steel Keypads - Self contained
4 beeps indicate
a data computing error
G. Audible Feedback
The audible signal is enabled in programming mode and
when the relay is energised after a valid code.
To enable the audible feedback on a key press:
1. Enter the master code twice
(1 2 3 4 5 default value master code):
2 beeps are emitted to confirm entry in programming
mode (orange LED lights ON).
2. Press
*
5:
- One beep is emitted.
- Press 0 to disable the audible signal during
a keypress.
- Press 1 to enable the audible signal during
a keypress.
- One beep confirms the new setting.
3. Press # to exit from programming:
2 beeps are emitted to confirm exit from
programming mode (The Orange LED lights OFF).
H. Panic Mode
1. Enter the master code twice
(1 2 3 4 5 factory default value master code):
2 beeps are emitted to confirm entry
in programming mode. (Orange LED lights ON)
2. Press
*
6:
- One beep is emitted.
- Press 0 to disable the panic function.
- Press 1 to enable the panic function.
3. Press # to exit from programming mode:
2 beeps are emitted to confirm exit
from programming mode
(Orange LED lights OFF).
Panic Function
- Press
*
# keys simultaneously to activate relay 2.
- Enter any user code from group 2 stop the panic
function and then deactivate relay 2.
6
position.eu.com
I. Security Levels
1. Enter the master code twice
(1 2 3 4 5 factory default value master code).
2 beeps are emitted to confirm entry
in programming mode. (Orange LED lights ON).
2. Press
*
7:
- One beep is emitted.
- Press 0 to disable the security.
- Press 1 for a keypad lock out of 30 seconds
after 4 invalid codes (not applicable
if the panic function is enabled already)
- Press 2 for a keypad lock out of 60 seconds
after 4 invalid codes (not applicable
if the panic function is enabled already)
- Press 3 for a permanent keypad lock out
after 4 invalid codes (disable keypad lock out
with the master code).
- Press 4 to activate relay #2 after 4 invalid use
code (enter any user code from group #2
to deactivate relay #2).
3. Press # to exit from programming mode:
2 beeps are emitted to confirm exit from
programming mode (Orange LED lights OFF).
EN
Publicidad
Tabla de contenido
