Axkid Wolmax Manual Del Usuario página 8

Attaching The Tether Straps
Detach the tether strap' s metal clip from the child restraint, press the grey button (M) and pull
18
the loop end out to maximise the length of the strap.
To attach the tether straps to an anchor point, wrap the strap around the chosen anchor point
19
and pass the metal clip through the loop.
Reattach the metal clips to each side of the child restraint and pull the free ends of both tether
20
straps until you have tensioned them. Pull each strap once again as hard as possible to ensure
the child restraint is secured tightly.
Unfold the support leg (O) out to its maximum angle. Pull out the top latch (P) to release the
21
upper part of the support leg until it reaches the floor. If the support leg does not reach the floor,
repeat with the lower latch (Q).
It is important that you check that the support leg is at an angle over 80 degrees from the back
22
of the seat. You could check this by ensuring that the support leg is further away from the seat
than the vertical line.
23
Now firmly pull the straps on both sides of the seat to make sure that your seat is fully secured.
If you have installed Wolmax in the back seat you can now move the front seat to a comfortable
position.
Note: The back of the child restraint may, but does not need to be in contact with the back of the front
seat.
Tips For Attaching The Tether Straps
When installing the Wolmax on a back seat, wrap the tether straps through either the rear of the
24
front seat rails (i), or the hinge of the front seat (ii).
When installing the Wolmax in the front passenger seat, the tether straps should be wrapped
25
around the nearest suitable anchor point (i) that will allow the straps to be tightened fully.
Anchor points set further back (ii) can be used and if need be the straps can be crossed over
(iii) and even looped together (iv).
7