installing your washer
IMPORTANT NOTE TO INSTALLER
Please read the following instructions carefully before installing your washer.
These instructions should be retained for future reference.
We recommend you hire a professional to install this washer.
Installation fl ow chart
Removing the
Selecting
shipping bolts
a location
(*Drum only)
[Running a test cycle]
Run a test cycle(Rinse+Spin)
with small amount of laundary
(about 4~5 Towels)
Please check again before steps.
STEP 1 Selecting a Location
Before you install the washer, make sure the location:
•
Has a hard, level surface without carpeting or fl ooring that may obstruct ventilation.
•
Is away from direct sunlight.
•
Has adequate ventilation.
•
Is not exposed to freezing temperatures (temperatures under 32 °F or 0 °C).
•
Is away from heat sources such as oil or gas.
•
Has enough space so that the washer doesn't rest on its power cord.STEP 2
Connecting the water and the drain
Connecting the water supply hose
Before installing the water supply hoses, make sure there are
rubber gaskets inside the fi ttings at both ends of each new
CAUTION
water hose. Installing the water supply hoses without rubber
gaskets can cause water leakage.
When you initially install the washer, be sure to use new hoses.
Failing to do so may result in a water leakage or overfl ow and
CAUTION
may damage your property.
Do not connect multiple water supply hoses together to
increase the length of the supply hose. Hoses connected this
CAUTION
way can leak and the leakage can cause electrical shock. If a
hose is too short, replace the hose with a longer, high pressure
hose.
WA7000M_DC68-03774A-03_EN.indd Sec3:14
WA7000M_DC68-03774A-03_EN.indd Sec3:14
Connecting the water
Adjusting the
and the drain
levelling feet
Does a
Laundary machine
Vibrate?
Yes
English - 14
Powering your
washing machine
Running
Finish the
a Calibration
installation
No
mode
Coupling
Rubber Washer
4/12/2018 3:43:37 PM
4/12/2018 3:43:37 PM