Designs Customer Service. walls. Should you have any doubt on your wall that may hinder the movement of the screen on Salamander Designs cannot be held liable for any material or its strength (resistance), please ask a its support. damage or injury caused by incorrect mounting, Qualified Contractor.
Si usted tiene alguna duda sobre el movimiento de la pantalla se detenga. De lo contrario, Salamander Designs no se hace responsable de los material de su pared o su fortaleza (resistencia), por favor, estos topes pueden resultar aplastados o pinzados daños o lesiones causados por el montaje incorrecto, el...
Service Après-Vente Salamander Ne pas poser d’objets entravant les mouvements de cinder block walls". Si vous avez des doutes sur le Designs. Salamander Designs ne pourra être tenu l’écran sur le support. matériau constituant votre mur ou sur sa résistance, responsable de dommages ou de blessures attribuables Ne pas permettre l’accès à...
Página 5
Screw 4 x 20 mm Screw 6 x 12 mm Screw 4 x 20 mm Spacer 6 mm Collar nut 6mm Screw 4 x 10 mm Rubber ring 3 mm Washer 6 mm Washer 4 mm x 10 Salamander Designs Ltd. PM100/S...
Página 6
3 mounting holes. For masonry construction, use 7/16” (11mm) bit. 5/32” (4mm) Drill bit One Stud Mounting Two Stud Mounting Lag Screw 6 x 70 mm Lag Screw 6 x 70 mm Washer 6 mm Washer 6 mm Salamander Designs Ltd. PM100/S...
Página 7
Remove Plastic Caps from the top and bottom Connect IR Sensor Connect Power Cable Route cables as shown in channel Note: You may use tape to keep wires DANGER: Electric Shock Hazard! in channel for subsequent steps Salamander Designs Ltd. PM100/S...
Página 8
WARNING: Make sure the wires stay in the channel as shown in step B4. Pinching or crushing cables can cause malfunction or injury. Break off corner of bottom cap to allow wires to pass Insert plastic caps on top and bottom Salamander Designs Ltd. PM100/S...
WARNING: Do not ever slide the PILOTMOTION on the wall plate with the screen mounted. Add Security Bolt Allen wrench #2.5 Screw 4x 20 mm Bottom Right for security bolt WARNING: The use of the security bolt is mandatory for proper installation. Salamander Designs Ltd. PM100/S...
Página 10
Spacer 6 mm Allen wrench #2.5 Screw 4 x 20 mm Screw 4 x 10 mm Allen wrench #3 Rubber ring 3 mm Washer 4 mm Allen wrench #4 Screw 6 x 12 mm x 10 PM100/S Salamander Designs Ltd.
Página 11
VESA 120x180 Combine Tilt Mechanism and Adapter Plate Affix TV on PILOTMOTION Thumbnut Screw 4 x 10 mm WARNING: The use of the Thumbnut is manditory for proper installation. Salamander Designs Ltd. PM100/S...
Página 12
( ). ( 2 toute collision avec son environnement et de procurer un secteur les réglages restent enregistrés. Ils peuvent être bips courts : « bip », « bip »). meilleur confort visuel. modifiés en suivant la même procédure. Salamander Designs Ltd. PM100/S...
• Liability : functionally equivalent to the original product, or (3) LIMITATION, WARRANTIES OF MERCHANTABILITY 1) SALAMANDER DESIGNS LTD. will not be liable for refund the purchase price of the product. AND FITNESS FOR A PARTICULAR PURPOSE. IF any damage or injury caused by incorrect mounting, SALAMANDER DESIGNS LTD.
(2) cambiará el producto por un producto nuevo o DER DESIGNS LTD. ESPECÍFICAMENTE DESCONOCE 1) SALAMANDER DESIGNS LTD. no se hace responsable de que haya sido fabricado a partir de piezas nuevas o usadas TODAS Y CADA UNA DE LAS GARANTÍAS IMPLÍCITAS los daños o lesiones causados por el montaje incorrecto, el...
Página 15
(b) les produits RÉGLEMENTATIONS RELATIVES À LA PROTECTION DES exposées ci-après : de tiers (non SALAMANDER DESIGNS LTD. ) ; (c) les dommages CONSOMMATEURS DANS LA VILLE, LE PAYS OU L’ÉTAT DANS SALAMANDER DESIGNS LTD. garantit le PILOTMOTION résultant d’une intervention réalisée par un personnel autre que celui...
Página 16
VESA 75, 100, 200, 100x200, 120x180, 200x200 • Charge maxi : 66 lbs (30 kg) • Tension d’alimentation : 120-240 V, 50-60 Hz • Courant nominal : 27 mA (sous 120V) For technical support and troubleshooting, contact Salamander Designs directly 800-898-9005 800-898-9005 Website: www.SalamanderDesigns.com...