Makita DUC204 Manual De Instrucciones página 19

Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Tool / battery protection system
The tool is
a tool/battery protection system.
This system
cuts off
the motor
tool and
The tool
automatically stop during operation if the
tool or battery is placed under one of the following
conditions:
Overload protection
When the battery is operated in a manner that causes it
to draw an abnormally high current, the tool
automatically stops and the main power lamp blinks in
green. In this situation, turn the tool off and stop the
application that caused
to become overloaded.
turn the tool on to restart.
Overheat protection
When the tool or battery is overheated, the tool stops
automatically and the main power lamp lights up in red.
In this case, let the tool and battery cool before turning
the tool on again.
NOTE: In high temperature environment, the overheat
protection likely to work and the tool stops
automatically.
Overdischarge protection
When the battery capacity is not enough, the tool stops
automatically and the main power lamp blinks in red. In
Remaining
capacity
Blinking
75 % to 100%
50 % to 75%
25 % to 50%
0 % to 25%
Charge the
battery.
The
may have
malfunctioned.
equipped with
automatically
power to
to extend
battery life.
will
the tool
Then
this case, remove the battery from the tool and charge
the battery.
Main power switch
WARNING:
switch when not in use.
To turn
press
switch
power
in
off,
again. ► Fig.5:
power switch
NOTE: The
ba
blinks
the
unoperatable conditions. The
in
following
•
When
the
while
and the switch trigger.
•
When
switch
chain
•
When
chain
down the lock-off lever and pulling the
switch trigger.
NOTE: This
the
To
start
power switch will automatically shut down
when the switch trigger is not pulled for a certain
period after the main power switch is turned on.
You can
in
mode
branches or
To
in
mode,
is
main power switch for a few seconds until the main
power lamp lights up in yellow.
NOTE: You
tool
Boost
Depending on the usage conditions, this mode shifts
to the normal mode in less than 30 seconds.
NOTE: If the main power lamp blinks in yellow when
you press the main power switch for a few seconds,
the Torque
19 ENGLISH
Always turn off the main power
on the
the main
until the
lamp lights
green. To
press the main power switch
1. Main power lamp 2. Main
main power
in green
switch trigger is pulled under
lamp
one of
conditions.
you turn
main power
holding down the lock-off lever
you pull
trigger while
brake is applied.
you release
brake while
chain saw
auto power-off function.
avoid unintentional
up, the
use the
the Torque
for cutting
hard
use the
the Torque
when the
turned off,
can use
in the
mode up to 30 seconds.
Boost mode
tool,
power
main
up
turn
lamp
if
blinks
the
on
switch
the
the
the
holding
employs
main
tool
Boost
thick
branches.
tool
Boost
tool
press the
the
Torque
is