General Operation - IROX JB913R Manual Del Usuario

P/N.: 086L001545-338 REV1
Page 4 of 44
INSTALLING AND REPLACING OF
BATTERY
The Thermo-Hygrometer uses one piece UM-4 or 'AAA' size
battery ( 1.5V DC )
Follow these steps to install or replace the battery
1. Slide the battery door in the direction of the arrow.
2. Insert the battery as indicated by the polarity symbols
(+ and -) marked inside the battery compartment.
3. Replace the battery door.
Notes: After you install or replace the battery, it takes time for
sampling once again both the temperature and humidity data. The
display will show full segment for 1 to 2 seconds, then shows the
updated temperature and humidity reading.
DISPLAY AND FUNCTIONS
Indoor Indoor
or outdoor or outdoor
temperature temperature
reading
indicator
Comfort Indoor relative
indicator humidity reading

GENERAL OPERATION

This Thermo-Hygrometer will measure / display indoor temperature
( the air temperature measured by the sensor built inside the unit )
or outdoor temperature ( the air temperature measured by the
detachable external sensor probe ) and indoor relative humidity
( the relative humidity measured by the sensor built inside the unit ).
It can be set to display the indoor/outdoor maximum or minimum
temperature and indoor relative humidity recorded.
Note:
When the outdoor temperature is over the measuring range, flashing
digit '-50'( ° C) / '-58'( ° F) appears on the display ( below –50°C /
-58°F ) or '70'( ° C) / '158'( ° F) appears on the display ( above +
70°C / + 158°F )
When the indoor temperature is over the operating range, it fades
out on the display ( below 0°C / + 32°F ) or blacks out on the
display ( above + 50°C / + 122°F )
This Thermo-Hygrometer will continue to record the indoor /
outdoor maximum, indoor / outdoor minimum temperature and
humidity changes, whether displaying current, maximum or
minimum temperature readings.
2