IROX JB913R Manual Del Usuario página 7

P/N.: 086L001545-338 REV1
Page 7 of 44
HOW TO SELECT THE TEMPERATURE
UNITS OF MEASURE
The switch on the back of the Thermo-Hygrometer allows you to
select between degrees Celsius and Fahrenheit. Set the switch to
'°C' for selecting Celsius and to '°F' for selecting Fahrenheit.
'°C' Position '°F' Position
Reading in °C Reading in °F
LOW BATTERY SIGNAL INDICATION
If battery power becomes low, the 'BATT' indicator will be
displayed at the top right corner of the display. Replace the battery
when the 'BATT' indicator is displayed.
HOW TO RESET THE UNIT
If your Thermo-Hygrometer does not operate properly, take out
the battery from the unit for 4 to 5 seconds, then reinstall the battery.
MOUNTING THE OUTDOOR
TEMPERATURE SENSOR PROBE
You can mount the outdoor temperature sensor probe by following
steps:
1. Drive a screw into the wall at the location you choose for the
sensor probe to fix the wire attachment to the wall.
2. Route the sensor probe cable through a window.
3. Locate sensor probe into wire attahment.
INDOOR
Wire attachment
Note: Locate the sensor probe away from direct sunlight and heavy
precipitaiton.
5
OUTDOOR
Outdoor
sensor
probe
Screw