Parts Diagram; Installation Method - Telstar TVO016110MD Manual De Instrucciones

PARTS DIAGRAM

1 2 3
Note:
Due to slight difference between the various models of products, please be subject to real objectives for
installation, and the diagram is for reference only.

INSTALLATION METHOD

Please use the following order in the correct installation.
Please keep the packaged items in order to facilitate the use during the fan storage.
1. Remove the chassis (as shown in Figure 1)
• Use a screwdriver to remove the screws from the fixed plate and the chassis
counterclockwise, rotate the chassis and remove the chassis.
2.
Installation of rear grill (as shown in Figure 2)
• Unscrew the spinner and plastic nut from the front of the motor.
• Insert the rear grill and align the positioning holes of the rear grill with the locating
pins of the front housing of the motor.
• Reinstall the plastics nut to be locked and fixed with the rear grill.
3.
Install the blades (as shown in Figure 3)
• Insert the blades into the motor shaft and press it down, and then make the
groove on the back of the blades lock on the limit pin of the motor shaft.
• Screw the spinner in the motor shaft in the counterclockwise direction for
tightened locking.
Notes: The spinner cannot be screwed tightly; in general, proper tightening is just
enough, or otherwise, it is easy to damage the spinner.
4 5 6 7 8 9
1.Decorative ring 2.Front grill
3.Spinner
5. Plastic nut
7.Rear grill
9.Spacer pin
11.Base
10 11 12
7
ORBIT FAN
TVO016110MD
4. Fan blade
6.Movable splint
8.Motor shaft
10.Motor
12.Chassis
Figure 1
Figure 2
Figure 3