Telstar TVO016110MD Manual De Instrucciones página 8

4.
Installation of front grill (as shown in Figure 4)
• Align the screw holes for installation of the front and rear grill.
• Put the front grill and rear grill together, and then fasten the movable splint on
the rear grill to make the front grill close to the rear grill.
• Insert the fixed screw through the mounting screw holes of the front grill and
rear grill and then tighten the nut up.
5.The installation of fan (as shown in Figure 5)
• Use cement nails (or screws) to fix them to the interior ceilings through the four
holes in the chassis.
• Align the stand at the bottom of the chassis with the holes of the chassis, and
rotate it in the clockwise direction and really enter.
• Align the screw hole of the plate with the screw holes on the chassis and fix it with the screw.
Notes: 1.Please connect the ground wire when installing the fan.
2.The installation distance of the fan from the ground height is not less than 2.3 meters.
6.
The installation of the governor (as shown in Figure 6)
• Use cement nails (or screws) to fix it to the appropriate position on the wall
through six holes on the rear housing of the governor (any two holes of 6 holes).
• Remove two screws in the front housing of the governor and push two screw
holes on the front housing with a screwdriver to remove the screw trim.
• Align the front housing of the governor with the rear housing of the governor
and fix the front and rear housing of the governor with the screws removed from the front housing, and then
install the screw trim.
7.
Power connection (as shown in Figure 7)
• Follow the above steps to install the fan and switch box, and then connect the
power supply.
Notes:
The users must install power supply full pole disconnect device with clearance
between open contacts of less than 3mm in fixed wiring.
8
ORBIT FAN
TVO016110MD
Figure 4
Movable
splint
Figure 5
Figure 6
Figure 7
220V