Description Of The Crimping Head - Weidmuller EPG 60 Manual De Instrucciones Original

The charging time is about 30 minutes for a 1.5 Ah battery. The battery's charge level is dis-
played by a LED on the charger.
The charge status can be queried by pressing the button on the battery. To do this, the battery
may remain inserted in the EPG 60 Power Tool, however, the tool must be switched off at least 1
minute before this (otherwise, the display will be inaccurate).
The number of illuminated LEDs describes the charging status. One fl ashing LED means a
power reserve of 10%. The LED display on the battery should be used only to determine the
power reserve.
CAUTION
Store battery and battery charger in a dry place away from humidity.
The battery should not be stored for long time (approx. 1 month or more) in com-
pletely discharged state.
The charging process must be carried out only at temperatures between 0 °C and
+65 °C. Do not charge defective batteries.
Never charge the battery in the vicinity of fl ammable materials of gases.
Remove the plug from the socket after charging.
The charger must not be exposed to rain.
Before using the charger and battery, check them both for any defects and
damage.
Never open the charger or a battery.
For more information, please refer to the operating instructions by TTI supplied with the EPG 60
Power Tool.
3.3

Description of the Crimping Head

Pos.-No. Designation
[ 1 ] Crimping head
[ 1.1 ] Crimping dies holder
[ 1.2 ] Hook
[ 1.3 ] Bracket
[ 1.4 ] Locking pins
[ 1.5 ] Pair of crimping dies
The crimping head is suitable to crimp aluminum and copper lugs and connectors with a
diameter up to 300 mm².
30
Function
60 kN Crimping head to crimp
connecting material up to 300mm²
Seat of crimping dies
to open/close the crimp head
moveable press insert seat with
locking
To secure the press inserts
Interchangeable dies for different
cable cross-sections
1.4 1.1
1.3 1.5 1.2
2515710000/00/04.2017
1