Battery Replacement & Care; Low Battery Indication - Amprobe NCV-1000 Serie Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EMC
Compliance
Certifications
BATTERY REPLACEMENT & CARE

Low Battery Indication

The NCV-1030 and NCV-1040 Testers provide a low
battery indication in the form of a slowly blinking
red LED upon power on when battery level is low
and the batteries should be replaced. At that point
no voltage indication is possible.
The NCV-1020 does not provide the same
indication; instead, batteries will need to be
replaced when no LED appears upon power on.
Battery Replacement
To remove the battery cap, use the thumb grip to
pull it upwards and outwards. Remove batteries
and replace with (2) AAA 1.5 V alkaline batteries,
noting the battery orientation as shown on the
side of the tester. Replace the cap.
If the Tester will not be used for a long period
of time, remove the batteries.
Cleaning
The Tester can be cleaned with a mild solution of
soapy water. Apply sparingly with a soft cloth and
allow to dry completely before using. Do not use
aromatic hydrocarbons, gasoline, or chlorinated
solvents for cleaning.
IEC 61326-1
Korea (KCC): Class A Equipment
(Industrial Broadcasting &
Communication Equipment)
This product meets requirements
[1]
for industrial (Class A) electromagnetic
wave equipment and the seller or
user should take notice of it. This
equipment is intended for use in
business environments and is not to
be used in homes.
Latch
7
Battery Cap
[1]

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ncv-1020Ncv-1030Ncv-1040

Tabla de contenido