Publicidad
Idiomas disponibles
Idiomas disponibles
The receiver module that sits atop the frame requires (1) 9V
battery. Remove the screws on each side of the receiver and
remove the cover. Tightly connect the 9v square battery to the
battery boot and replace the cover.
Operational Warnings – The GFL3000 transmits a high
voltage charge. Do not turn the transmitter on until all hook-
ups are complete. This means the alligator clip to the ground
stake and the alligator clip to the wire. NEVER TURN ON THE
UNIT WHEN ANYONE IS TOUCHING THE CABLE, GROUND
STAKE, OR ANY PART OF THE TRANSMITTER. Disconnect
the wire to be tested from any other service, components, or
anything that might be affected by high voltage. Completely
isolate the cable.
FAILURE to follow instructions could lead to injury or death.
Operation
To watch a video on how to use the GFL3000, visit our YouTube
channel ArmadaTech, and search "GFL3000". You can also scan
the QR code below with your smart phone, or visit the following
website address:
https://www.youtube.com/watch?v=z6-V_mlJpWU.
1.
Disconnect cable to be tested at both ends. Be sure you
are disconnected from power, components or anything
else that will transmit electrical current. This isolates the
4
Publicidad
