Publicidad
Idiomas disponibles
Idiomas disponibles
cable and forces the current generated by the GFL3000 to
exit the cable at the fault.
2.
Assemble the A-Frame receiver by placing the small
electronic receiver module on top of the receiver frame and
secure it with the 2 thumb screws attached to the A-Frame.
3.
Starting at either end of the cable and with the transmitter
off, connect the black alligator clip lead to the ground stake
and shove the stake into the ground as deeply as possible.
Connect the red alligator clip lead to the cable to be tested
(See Figure 2).
4.
After being sure that no one is touching the stake, cable or
leads, turn the GFL3000 transmitter on by placing the
rocker switch in the "on" position. The transmitter will
produce an audible beeping sound indicating the current is
being transmitted. Do not handle any component, cable, or
stake while the GFL3000 is operating.
5.
Select low (2400v) or high (3200v) power as per your
preference. High power will find large or small leakages
while low power will concentrate on larger faults. If you
5
Publicidad
