Before Use; Mounting The Agitator; Dismantling The Agitator; Installing The Support Bracket - Parkside PFMR 1400 B1 Instrucciones De Utilización Y De Seguridad

Safety notes for paint and mortar mixer / Before use / Operation
tool striking hidden electical lines or
its own power line. Contact with a live wire
could cause metal parts of the device to become
live and lead to electric shock.
Do not use device in surroundings with explosive
atmospheres. Do not mix solvents or substances
containing solvents with a flashpoint below 21 °C.
Do not place cables around any part of your
body.
Only turn the device on or off when it is in the
mixing vessel. Make sure that it is securely and
safely positioned. When mixing, do not place
hands or objects in the mixing vessel.
If the sound pressure level at the work station
exceeds 85 dB(A), wear hearing protection!
Wearing work gloves and safety glasses is rec-
ommended when working with the agitator.
Wearing snug fitting clothing is required.

Before use

Always pull the mains plug before executing
settings on the device.
Mounting the agitator (see Ill. A)
Firmly screw the shaft
6 b
Subsequently, screw the agitator
agitator shaft with the M-14 inner threading
Secure the chuck with an open-end spanner
and tighten the stirrer
6
end spanner .
2

Dismantling the agitator

To remove the agitator, repeat the process in
the reverse order.

Installing the support bracket

Install the support bracket
four included crosshead screws in the designat-
ed location on the handle (see Fig. C).
to the mixing spiral .
6 a
into the
6
.
3
2
with a second open-
by securing the
7

Using the support bracket

Use the support bracket
or to set it on the ground. This will prevent it
from dirtying.

Operation

Turning the device ON / OFF

(see Ill. B)
Switching on:
Press the ON / OFF switch
Switching off:
Release the ON / OFF switch
Switching on permanent operation:
Secure ON / OFF switch
button .
4
Switching off permanent operation:
Press ON / OFF switch
Setting the speed (see Ill. B)
Note: The ON / OFF switch
speed control.
Press the ON / OFF switch
the speed.
Increase the pressure to increase the speed.

Working with the mixer

Submerge the mixer in the mixture at a low
speed.
After the agitator has been submerged com-
pletely, you may increase the speed.
During the mixing process, move the agitator
around the mixing vessel and mix the mixture
until it is completely processed.
to hang the device
7
.
5
.
5
with hold-to-run
5
quickly.
5
has a variable
5
lighlty to reduce
5
GB/MT 25