Interface Description; Steam Function; Bed Programming - Nilo WET TABLE 9020 Manual De Empleo

Edition
37 EN

BED PROGRAMMING

WET TABLE
001 11
/

INTERFACE DESCRIPTION

STEAM BATH KEYS SERVICE KEY HEIGHT ADJUSTING KEYS
CHROMOTHERAPY KEY
Pict.10 Interface description

STEAM FUNCTION

The bed is programmable to execute steam cycles of a duration and temperature to be set.
Caution! For a correct operation of the steam cycles, bed covers must be set.
Referring to the interface figure, the function of each element is defined.
1 PROG1 Selection cycle 1 (time and temperature reset)
2 PROG2 Selection cycle 2 (time and temperature reset)
3 PROG3 Selection cycle 3 (time and temperature reset)
The Display on the left shows the time left to go and the temperature set.
Time: mm:ss - Temperature: Histogram
+,- TIME Increase, decrease the duration of a steam cycle Step 1 minute
+,- TEMPERATURE Increase, decrease the operating temperature Step: 1°C
START/STOP Starts/Stops a steam cycle
The selection of a steam cycle takes place by pressing one of the keys relative to the reset program-
mes (PROG1, PROG2, or PROG3).