Starting/Stopping Instructions - Troy-Bilt TB310QS Manual Del Operador

WARNING:
area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
WARNING:
starting position when pulling the starter rope (Fig. 11).
To avoid serious injury, the operator and unit must be
in a stable position while starting.
Do not set unit on any surface except a clean, hard
area while starting. Debris such as gravel, sand,
dust and grass could be picked up by the air
intake and thrown out by the discharge opening.
This could damage the unit, property, or cause
serious injury to bystanders or the operator.
STARTING INSTRUCTIONS
1. Mix gas with oil. Fill fuel tank with fuel/oil mixture. See
Oil and Fuel Mixing Instructions.
WARNING:
always remove the vacuum bag prior to
refueling the unit. The bag may become a
fire hazard when saturated with fuel.
NOTE: The throttle control will remain in the position it's
placed until moved. Fast position is to the right.
Also, there is no need to turn the unit on. The On/Off
Stop Control is in the ON (I) position at all times.
2. Set the blower/vacuum mode change-over lever to the
up position (Blower Mode). See Operating as a Blower.
This prevents the vacuum bag from filling up while
starting the engine.
3. Fully press and release the primer bulb 10 times,
slowly. Some amount of fuel should be visible in the
primer bulb and fuel lines (Fig. 10). If you can't see
fuel in the bulb, press and release the bulb as many
times as it takes before you can see fuel in it.
4. Place the unit in the starting position (Fig. 11). Move the
throttle control to the idle position (
5. Push the blue EZ-Start™ Lever towards the primer
bulb until it clicks and locks into place (Fig. 10).
6. Pull the starter rope out with a controlled and steady
motion up to 10 times. Repeat until the engine starts.
NOTE: The unit uses Spring Assist Starting™, which
significantly reduces the effort required to start the
engine. You must pull the starter rope out far enough
to hear the engine attempt to start. There is no need
to pull the rope briskly-- there is no harsh resistance
when pulling. Be aware that this starting method is
vastly different from (and much easier than) what you
may be used to.
7. When the engine starts, move the throttle control to the
fast position (
30 seconds. This will warm up the unit. The EZ-Start™
Lever will click off automatically when you move the
throttle control to the fast position.
IF...
The engine does not start, go back to step 3.
NOTE: If you are having trouble starting the unit or are
operating in extreme temperatures (below 40º F,
above 90º F), refer to the Troubleshooting section.

STARTING/STOPPING INSTRUCTIONS

Operate this unit only in a
well- ventilated outdoor
Avoid accidental starting.
Make sure you are in the
To avoid serious
personal injury,
) (Fig. 9).
) and let the engine warm up for 15 to
Throttle Control
On/Off Stop Control
Fig. 9
Primer
Bulb
Fig. 10
Starter Rope
Fig. 11
STOPPING INSTRUCTIONS
1. Move the throttle control to the idle position
( ). Allow the engine to cool down by
idling.
2. Put the On/Off Stop Control in the OFF (O)
position.
Idle Fast
Blue EZ-
Start™ Lever
11