Technical Characteristics - MADEL KSP–SUB Manual De Instalación

7. MOST FREQUENT ERRORS
ERROR
When the centre is powered
1
by 230 VAC, any led light up.
The right red led flashes
2
quickly.
(Zoning type installation)
5 min after switching the
centre on, the zone leds
3
flashes in all zones and all
grilles are closed.
Some of the zone led flashes
4
and the damper in this zone
is closed.
When the damper should
open  close
5
(And vice versa).
One of the dampers does
6
not work.
All of the dampers work
properly but the air
7
conditioning equipment does
not work.
The equipment switches on
and of with the MASTER at a
8
standstill or some zones
close or open without any
signal from the thermostat.

TECHNICAL CHARACTERISTICS:

Control board (receiver)
 Power: 230 VAC, 50/60 Hz.
 Power consumption: 4 VA
 2 Relay outputs. Maximum current load: 6 A .Cos
 Average scope: 50 m in free field. 20 m in the habitat.
 External aiming antenna.
 Size (mm): 105 x 90 x 60
 Carrier frequency (ISM Band, as per I-ETS 300-220 standard):
434.33 MHz (Optional: 433.92 MHz)
 Operating cycle <10%
 Receiver. Class III
 Protection level: IP 20
 Electric shock insulation Clase II.
 Operating temperature: 0 ºC a 55ºC.
 Storage temperature:: -10 ºC a 60 ºC.
Hereby MADEL ATD decalres that the KSP (control board + thermostat) is in compliance with the essential requirements and other relevant provisions
of Directive 1999/5/CE. http://www.madel.com/eng/pdf/Zoningconformidadksp.pdf
INDICADOR CAUSA
Lack of
voltage
Sensor error
Incorrect
configuration
communication
Motors badly
connected
Zone regulator
connection
Air conditioning
equipment badly
connected
Interference with
neighbouring
installations
Thermostat (transmiter)
 Power: 2 x 1.5 V LR06 AA batteries (supplied). Average

=1
 Battery wear indicator.
 Carrier frequency (ISM Band, as per I-ETS 300-220 standard):
 Average scope: 50 m in free field. 20 m in the habitat.
 Size (mm) (mm): 112 x 71 x 19.
 Operating temperature: 0 ºC a 55ºC.
 Storage temperature:: -10 ºC a 60 ºC..
 Wall attachment using screws (supplied)
 Protection level: IP 20
 ECO mode (ordered temp. variation of  3ºC)
SOLUCIÓN
Check that voltage reaches the
centre (230 VAC 10%).
 Connect the sound or leave the
resistance
default.
 Check thermostat configuration.
 Antenna not receiving.
position.
 The zone is badly configured in the
Bad thermostat SETUP.
 Interference in the communication.
Modify thermostat location.
 Thermostat battery low
 Check the motor connection.
Polarity (black -, red +)
 Check the motor connection.
Polarity (black -, red +)
 Check that the regulator is not
obstructed.
 Check the Sw1 configuration of the
control centre depending on the
machine type.

Check the equipment connection
to the board.
 Check that there are no two
thermostats
configuration.

Check whether there is some other
Zoning System with the same
series number installed in the
neighbouring households (0.03%
probability)
autonomy 1 year (or more).
434.33 MHz (Optional: 433.92 MHz)
ENGLISH
which is wired for
Modify
with the same
V. 03.12