Arregui CI10 Manual De Instrucciones página 8

CI10
EN
CORNER MOUNTED ASSEMBLY INSTRUCTIONS
H
1. Calculate in which position you want to
install the bolt, but always on the inside of
the door. Place the adhesive spacer (H)
as shown in the image, right up against
the lock box.
M
4. Once the base plate is pre-installed (B)
and, if necessary, the shims (C) and (D),
drill the holes and fasten it to the door
using the supplied screws (M).
G
7. Slid the lock bolts out and the adhesive
disks will stick to the door frame. Drill the
holes in the centre of the disk stuck to
the frame, with material-suitable tools.
Use the disk (G) as a template to drill the
holes. Never drill the holes bigger than the
template.
8
F
H
2. Place the door jamb plate (F) next to the
adhesive spacer (H) on the door frame.
The spacer marks the minimum distance
between the lock and the door jamb plate.
If they are not at the same height, you must
use parts (C) and (D) to fit the lock in step 4.
L
B
B
5. Screw the lock box (A) to the base plate
(B), using the 4 supplied screws (L).
F
8. Place the door jamb plate (F) fixing it
onto the door frame with the screws (M).
I
B
3. Fix the adhesive strips (I) onto the
back of the base plate (B) or on the
shims (C and D), to position it properly
on the door before drilling.
G
A
6. Remove the adhesive spacer. Place the
adhesive discs (G) on the sliding bolts of
the lock box.
M
Attention:
Check that the lock operates
correctly, but always from inside your
home.

See
video